Multiquip MQP20P manual Fuel SaFeTY, TOWiNg SaFeTY

Page 9

Safety Information

Fuel SaFeTY

DaNgeR

„DO NOT start the engine near spilled fuel or combustible fl uids. Diesel fuel is extremely fl ammable and its vapors can cause an explosion if ignited.

„alWaYS refuel in a well-ventilated area, away from sparks and open fl ames.

„alWaYS use extreme caution when working with flammable liquids.

„DO NOT fi ll the fuel tank while the engine is running or hot.

„DO NOT overfi ll tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system.

„Store fuel in appropriate containers, in well-ventilated areas and away from sparks and fl ames.

„NeveR use fuel as a cleaning agent.

„DO NOT smoke around or near the equipment. Fire or explosion could result

from fuel vapors or if fuel is spilled on a hot engine.

TOWiNg SaFeTY

CauTiON

„Check with your local county or state safety towing regulations, in addition to meeting

Department of Transportation (DOT) SafetyTowing Regulations, before towing your generator.

„Refer to MQ Power trailer manual for additional safety information.

„In order to reduce the possibility of an accident while transporting the generator on public roads, alWaYS make sure the trailer that supports the generator and the towing vehicle are mechanically sound and in good operating condition.

„alWaYS shutdown engine before transporting

„Make sure the hitch and coupling of the towing vehicle are rated equal to, or greater than the trailer “gross vehicle weight rating.”

„alWaYS inspect the hitch and coupling for wear. NeveR tow a trailer with defective hitches, couplings, chains, etc.

„Check the tire air pressure on both towing vehicle and trailer. Trailer tires should be inflated to 50 psi cold. Also check the tire tread wear on both vehicles.

„alWaYS make sure the trailer is equipped with a safety chain.

„alWaYS properly attach trailer’s safety chains to towing vehicle.

„alWaYS make sure the vehicle and trailer directional, backup, brake and trailer lights are connected and working properly.

„DOT Requirements include the following:

Connect and test electric brake operation.

Secure portable power cables in cable tray with tie wraps.

„The maximum speed for highway towing is 55 MpH unless posted otherwise. Recommended off-road towing is not to exceed 15 MpH or less depending on type of terrain.

„Avoid sudden stops and starts.This can cause skidding, or jack-knifi ng. Smooth, gradual starts and stops will improve towing.

„Avoid sharp turns to prevent rolling.

„Trailer should be adjusted to a level position at all times when towing.

„Raise and lock trailer wheel stand in up position when towing.

„Place chock blocks underneath wheel to prevent rolling while parked.

„Place support blocks underneath the trailer’s bumper to prevent tipping while parked.

„Use the trailer’s swivel jack to adjust the trailer height to a level position while parked.

MQP20P STANDBY GENERATOR • operation and parts manual — rev. #1 (11/28/11) — page 9

Image 9
Contents Model MQP20P Diesel engine exhaust and some Proposition 65 warningPage MQP20P Standby Generator Table of ContentsChoose from three easy options SaFeTY MeSSageS Safety InformationGeNeRaTOR SaFeTY GeNeRal SaFeTYRestricted. If the air fl ow is ENgiNe SaFeTYTOWiNg SaFeTY Fuel SaFeTYEleCTRiCal SaFeTY Grounding SafetyPower Cord/Cable Safety ENviRONMeNTal SaFeTY BaTTeRY SaFeTYSpecifications Dimensions Typical Generator Grounding Application InstallationIndoor Installation Outdoor InstallationMounting Generator GroundingGeneral information GeneratorCamlok outlet box panel Principle of operation EngineElectrONIC Governor System Item no Description Major componentsBasic Engine Components Basic engine componentsMicroprocessor Engine Controller MEC Digital controller panelOutlet connectors Connector outlet box and main circuit breakerSingle Phase Load Load application/generator outputGenerator Amperage Refueling Procedure Inspection/setupLubrication Oil Fuel CheckFuel Expands Air Cleaner Fan Belt Tension Cleaning the RadiatorBattery Coolant Antifreeze/summer coolantWiring Battery Cable InstallationAlternator Piping and Hose ConnectionStartup Starting Auto ModeBefore Starting Starting ManualEmergency Shutdown Procedure Normal Shutdown ProcedureBattery Charger and Jacket Water Heater Power Connections JacketWater Heater and Internal Battery ChargerProtective devices Protective devicesTransporting TransportingMaintenance Air Filter Dust IndicatorGeneral Inspection Air Filter Fuel Addition Cleaning Inside the Fuel TankRemoving Water from the Fuel Tank Fuel Tank InspectionVoltage regulator adjustments Radiator CleaningFlushing Out Radiator and Replacing Coolant PotentiometersGenerator Storage Adjustment ProcedureTroubleshooting Generator Troubleshooting GeneratorTroubleshooting Engine Troubleshooting engineTroubleshooting MEC20 Controller Troubleshooting controllerImproper calibration? Troubleshooting Voltage Regulator Troubleshooting Voltage RegulatorMaintenance Parts Locator Control BOX Generator Wiring Diagram single phaseCircuit Breaker BOX Generator Wiring Diagram three phase 505 K1 Explanation of Code in Remarks Column MQP20P with Perkins 404D-22 Diesel Engine 1 to 3 units Suggested Spare PartsHousing assy Part Name Engine and Generator Mounting assy GENERATOR, 30KW Fuel assy Part Name QTY Remarks Electrical assy BOLT, BATTERY, 10.38 Jacket Water HEater assy BRACKET, MOUNTING, Heater Solenoid assy BRACKET, Starter Solenoid Radiator assy Guard Air filter assy Cover Engine exhaust assy Exhaust Flex Engine Oil assy OIL Filler CAP Control panel assy PANEL, FRONT, Control Panel Controller assy MODULE, Output Expan MEC 2/20 W/CABLE Saddlebox assy Phase Units Circuit breaker assy Ground Camlok assy HousingCOVER, HINGED, Black FReigHT pOliCY Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help