Land Pride 22081 Engine Air Filter, Air Filter Maintenance Schedule, Air Filter Replacement Parts

Page 32

Table of Contents

Section 6 Maintenance

7.Remove belt by rolling it off over the drive pulley and then lifting it up off the driven pulley.

8.Reinstall new belt by placing it over the driven pulley and then rolling it over the drive pulley.

9.Re-tension power steering belt and tighten take-up bolt.

10.Reinstall belt cover and fasteners.

11.Reconnect battery negative cable.

12.Remove blocks securing cargo box up and lower cargo box.

Engine Air Filter

Refer to Figure 6-8

A specially designed high density paper filter element surrounded by an oil filled foam precleaner filter element cleans the air supplied to the engine. Protect your engine by ordering only genuine Land Pride parts when replacing the air filter elements.

NOTE: Do not operate engine with a damaged air filter or without the air filter elements installed. Dirt will enter the engine and cause a dust ingested engine failure.

Air Filter Maintenance Schedule

•Check air filter daily before starting engine for dirt and debri buildup. Also check daily for loose and damaged filter components. Tighten loose components and replace damaged components.

•Service precleaner foam element ever 25 hours of operation. Service more often when operating in extremely dusty or dirty conditions.

•Service paper element every 100 hours of operation. Service more often when operating in extremely dusty or dirty conditions.

Air Filter Replacement Parts

Order genuine Land Pride parts when replacing the precleaner element.

Description

Part No.

Precleaner Element (61 mm deep) . . . . 24-083-02-S Paper Element (65 mm deep) . . . . . . . . . 47-083-03-S

Precleaner Foam Element

Refer to Figure 6-8and Figure 6-9

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 24.

2.Safely secure the seat console in the raised position.

3.Loosen air cleaner cover knob and remove cover.

4.Remove outside precleaner element from the paper element.

5.Wash precleaner element with warm water and detergent. Rinse thoroughly to remove all traces of detergent. Do not wring precleaner. Squeeze excess water out and allow time to air dry.

6.Saturate precleaner with new engine oil and gently squeeze all excess oil out.

7.Inspect precleaner element for holes and tears before reinstalling it. Replace element if damaged.

8.Reinstall precleaner element over the paper element being careful not to damage the elements.

9.Reinstall air cleaner cover and secure with cover retaining knob.

Air Cleaner Cover

Air Cover Knob

21368

 

Figure 6-8

 

 

Element

Element Cover

Cover

Wing Nut

Paper Element

Behind Precleaner

 

 

 

Precleaner Foam

 

 

 

Element

 

21369

 

 

 

 

 

 

 

 

 

Figure 6-9

 

 

 

 

 

Air Cleaner

Rubber Seal On

 

Air Cleaner Stud

 

Base

 

 

21370

Figure 6-10

30

4400EX Heavy Duty Off Road Utility Vehicle 720-132M

7/01/05

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Gondo Table of Contents Safety First Using This ManualApplication IntroductionLand Pride Service Department East North Street Owner AssistanceSerial Number Plate Product SupportSafety Symbol Be Aware of Signal WordsImportant Safety Information For Your ProtectionPractice Safe Maintenance Tire SafetyPrepare for Emergencies Wear Protective EquipmentSafe Operating Procedures Table of Contents Safety Decals 818-543C838-492C 838-629C 838-486C 838-490C 838-628C 838-667C838-688C Machine RolloverDealer Service and Inspection List Pre-Delivery CertificatePre-Delivery and Check List Vehicle InformationDealer Delivery To Customer List Customer Acceptance ListOperating Instructions Operator ResponsibilitiesGeneral Operation Foot Operated Controls Hand Operated Controls Engine Hood ReleaseFuel Indicator SteeringSeat Belt Components Seat BeltsDriving Conditions Towing the Gondo Traverse Traveling on Steep HillsPulling Loads Towing Without a TrailerTraveling Tips From the Trail Masters Preparation and PlanningPlan Your Route Plan Your GearTable of Contents Options and Accessories Gondo OptionsDump Bed Option Tailgate Operation Cargo box option onlyGondo Accessories General Maintenance Prepare Vehicle for MaintenanceMaintenance Torque ValuesTire Maintenance Tire Inflation Chart Inflation PSI Front Tires Rear TiresJacking the Vehicle Seat BeltsBattery Jump Starting the BatteryElectrical System Prepare Vehicle to Jump-StartFuel System Disconnecting Jumper CablesConnecting Jumper Cables Emptying the Fuel Tank Fuel Filter and Fuel Line MaintenanceFilling the Fuel Tank Engine Maintenance Power Steering BeltGeneral Information High Altitude Carburetor KitAir Filter Maintenance Schedule Air Filter Replacement PartsPrecleaner Foam Element Engine Air FilterSpark Arrester Maintenance Schedule Spark Arrester Maintenance ProcedureSpark Arrester Replacement Parts Spark ArresterMaintenance Schedule Engine Oil Maintenance Schedule Engine OilLubrication and Fluids Engine Oil Type and CapacityRefer to Figures 7-1, 7-2, 7-3, 7-4 Engine Oil and Filter ChangeLand Pride Oil Filter Differential Maintenance Schedule Differential Oil Type and CapacityDifferential Oil Level Check Differential Oil ChangeTransmission Maintenance Schedule Transmission FluidTransmission Fluid Type and Capacity Transmission Oil Level CheckBrake Fluid Steering & Cargo Lift Cylinder FluidGrease Type Lubrication Driveline U-JointsPillow Block Bearing Rotating Bearing SurfacesSeasonal Storage Engine Preparation for StorageVehicle Storage Preparation Vehicle Removal From Storage PreparationIntroduction Light ScuffScratch Body RepairDeep Gouge Specifications and Capacities 4400EX Series GondoTable of Contents Troubleshooting Engine overheats Engine runs unevenlyEngine stops running Gear Shift is malfunctioningPark brake doesn’t work Starter cranks slowlySteering does not track correctly Steering play is excessiveVehicle speed does not reach 17 MPH Vehicle looses ground speed withoutIn-tpi Ft-lb Torque Values ChartAppendix Land Pride Limited Warranty Utility VehicleCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA

22081, 22076, 720-132M specifications

Land Pride is renowned for its high-quality agricultural and landscaping equipment, and among its impressive lineup, the Land Pride 720-132M mower stands out as a versatile solution for various mowing applications. Designed with performance and efficiency in mind, the 720-132M mower is perfect for both residential and commercial users looking for a reliable machine capable of handling diverse terrain and mowing conditions.

One of the key features of the 720-132M is its robust cutting deck, which measures 132 inches in width. This wide cutting capability allows for expansive mowing coverage in fewer passes, significantly reducing mowing time and increasing productivity. The deck is constructed from heavy-duty materials, ensuring durability and longevity even when used in challenging environments.

Equipped with a high-performance cutting system, the mower boasts engineered blades that provide a clean and precise cut, promoting healthier lawn growth. The unique blade overlap design ensures consistent cutting performance across the entire width of the deck, reducing the likelihood of uncut areas left behind.

The Land Pride 720-132M features adjustable cutting height settings, giving operators the flexibility to adapt the mower to various grass types and desired finish quality. This adjustability is crucial for achieving optimal results, especially when transitioning from different mowing conditions.

Safety is a top priority for Land Pride, and the 720-132M integrates several safety features to protect both the operator and the equipment. Its robust frame design provides stability during operation, while operator presence controls ensure the mower stops when the operator leaves the seat, mitigating the risk of unintended accidents.

The mower is compatible with a wide range of tractors, allowing for seamless integration with existing equipment. Its simple attachment system enables quick mounting and dismounting, making it user-friendly and convenient for varying mowing tasks.

Another notable technology in the 720-132M is its efficient power transfer system. The mower is designed to maximize performance while minimizing wear and tear on the tractor, ensuring that operators can tackle their mowing tasks with confidence and ease.

Overall, the Land Pride 720-132M mower, with its advanced technologies and features, stands out as a leading choice for those seeking reliable and efficient mowing solutions tailored to both professional and personal landscaping needs.
Top Page Image Contents