Land Pride 720-132M, 22076, 22081 manual Engine Oil and Filter Change, Land Pride Oil Filter

Page 36

Table of Contents

Section 7 Lubrication and Fluids

Engine Oil and Filter Change

Refer to Figures 7-1, 7-2, 7-3, 7-4 & 7-5

100 hrs / 6 mos.

Drain used engine oil while the engine and oil are still warm. The oil will drain more freely and carry away more impurities. Change oil as follows:

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 24.

2.Clean the area around the oil filter to keep dirt and debris out of the engine.

3.Place a suitable container below the engine to catch used oil as it drains. Remove filler cap. Turn oil drain valve 1/4 turn counterclockwise and pull out to drain oil.

4.Remove oil filter located on left side of engine with a filter wrench. Let remaining oil drain out.

5.Push oil drain valve in and turn clockwise until hand tight. Replace oil drain cap.

6.Clean oil filter base where the oil filter seats against it.

7.Place a new replacement filter in a shallow pan with the open end up. Pour new engine oil in through the threaded center hole until oil reaches the bottom of the threads. Allow one or two minutes for the oil to be absorbed by the filter material.

8.Coat new filter O-ring with clean engine oil and install filter to engine filter base.

9.Hand tighten oil filter until O-ring seats. Finish tightening by turning in the filter an additional 2/3 to 1 turn.

10.Dispose of used motor oil and filter in a manner that is compatible with the environment. Do not throw used oil in the trash, pour it on the ground, or down a drain.

11.Fill engine with recommended oil and quantity. Do not overfill. See "Engine Oil Type and Capacity" and "Engine Oil Level Check" on page 33.

12.Replace filler cap, start engine and check engine and oil filter for leaks. Correct any leaks before placing engine into service.

13.Stop engine and check oil level. Add additional oil if not to the full mark “F” on the dipstick.

Land Pride Oil Filter

Part No.

Part Description

5205002 KOHLER ENGINE OIL FILTER

Oil Drain Valve

Oil Drain Cap

21363

figure 7-3

Oil Filter

Base

Oil Filter

22069

Figure 7-4

21134

Oil Filter O-Ring

Figure 7-5

34

4400EX Heavy Duty Off Road Utility Vehicle 720-132M

7/01/05

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Gondo Table of Contents Safety First Using This ManualApplication IntroductionLand Pride Service Department East North Street Owner AssistanceSerial Number Plate Product SupportSafety Symbol Be Aware of Signal WordsImportant Safety Information For Your ProtectionPractice Safe Maintenance Tire SafetyPrepare for Emergencies Wear Protective EquipmentSafe Operating Procedures Table of Contents Safety Decals 818-543C838-492C 838-629C 838-486C 838-490C 838-628C 838-667C838-688C Machine RolloverDealer Service and Inspection List Pre-Delivery CertificatePre-Delivery and Check List Vehicle InformationDealer Delivery To Customer List Customer Acceptance ListOperator Responsibilities General OperationOperating Instructions Foot Operated Controls Hand Operated Controls Engine Hood ReleaseFuel Indicator SteeringSeat Belt Components Seat BeltsDriving Conditions Towing the Gondo Traverse Traveling on Steep HillsPulling Loads Towing Without a TrailerTraveling Tips From the Trail Masters Preparation and PlanningPlan Your Route Plan Your GearTable of Contents Options and Accessories Gondo OptionsDump Bed Option Tailgate Operation Cargo box option onlyGondo Accessories General Maintenance Prepare Vehicle for MaintenanceMaintenance Torque ValuesTire Maintenance Tire Inflation Chart Inflation PSI Front Tires Rear TiresJacking the Vehicle Seat BeltsBattery Jump Starting the BatteryElectrical System Prepare Vehicle to Jump-StartDisconnecting Jumper Cables Connecting Jumper CablesFuel System Fuel Filter and Fuel Line Maintenance Filling the Fuel TankEmptying the Fuel Tank Engine Maintenance Power Steering BeltGeneral Information High Altitude Carburetor KitAir Filter Maintenance Schedule Air Filter Replacement PartsPrecleaner Foam Element Engine Air FilterSpark Arrester Maintenance Schedule Spark Arrester Maintenance ProcedureSpark Arrester Replacement Parts Spark ArresterMaintenance Schedule Engine Oil Maintenance Schedule Engine OilLubrication and Fluids Engine Oil Type and CapacityEngine Oil and Filter Change Land Pride Oil FilterRefer to Figures 7-1, 7-2, 7-3, 7-4 Differential Maintenance Schedule Differential Oil Type and CapacityDifferential Oil Level Check Differential Oil ChangeTransmission Maintenance Schedule Transmission FluidTransmission Fluid Type and Capacity Transmission Oil Level CheckBrake Fluid Steering & Cargo Lift Cylinder FluidGrease Type Lubrication Driveline U-JointsPillow Block Bearing Rotating Bearing SurfacesSeasonal Storage Engine Preparation for StorageVehicle Storage Preparation Vehicle Removal From Storage PreparationIntroduction Light ScuffScratch Body RepairDeep Gouge Specifications and Capacities 4400EX Series GondoTable of Contents Troubleshooting Engine overheats Engine runs unevenlyEngine stops running Gear Shift is malfunctioningPark brake doesn’t work Starter cranks slowlySteering does not track correctly Steering play is excessiveVehicle speed does not reach 17 MPH Vehicle looses ground speed withoutTorque Values Chart AppendixIn-tpi Ft-lb Land Pride Limited Warranty Utility VehicleCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA

22081, 22076, 720-132M specifications

Land Pride is renowned for its high-quality agricultural and landscaping equipment, and among its impressive lineup, the Land Pride 720-132M mower stands out as a versatile solution for various mowing applications. Designed with performance and efficiency in mind, the 720-132M mower is perfect for both residential and commercial users looking for a reliable machine capable of handling diverse terrain and mowing conditions.

One of the key features of the 720-132M is its robust cutting deck, which measures 132 inches in width. This wide cutting capability allows for expansive mowing coverage in fewer passes, significantly reducing mowing time and increasing productivity. The deck is constructed from heavy-duty materials, ensuring durability and longevity even when used in challenging environments.

Equipped with a high-performance cutting system, the mower boasts engineered blades that provide a clean and precise cut, promoting healthier lawn growth. The unique blade overlap design ensures consistent cutting performance across the entire width of the deck, reducing the likelihood of uncut areas left behind.

The Land Pride 720-132M features adjustable cutting height settings, giving operators the flexibility to adapt the mower to various grass types and desired finish quality. This adjustability is crucial for achieving optimal results, especially when transitioning from different mowing conditions.

Safety is a top priority for Land Pride, and the 720-132M integrates several safety features to protect both the operator and the equipment. Its robust frame design provides stability during operation, while operator presence controls ensure the mower stops when the operator leaves the seat, mitigating the risk of unintended accidents.

The mower is compatible with a wide range of tractors, allowing for seamless integration with existing equipment. Its simple attachment system enables quick mounting and dismounting, making it user-friendly and convenient for varying mowing tasks.

Another notable technology in the 720-132M is its efficient power transfer system. The mower is designed to maximize performance while minimizing wear and tear on the tractor, ensuring that operators can tackle their mowing tasks with confidence and ease.

Overall, the Land Pride 720-132M mower, with its advanced technologies and features, stands out as a leading choice for those seeking reliable and efficient mowing solutions tailored to both professional and personal landscaping needs.
Top Page Image Contents