2 WALL: TOWER, FIXED WALL AND CURVED GLASS INSTALLATION
STEP 1
Position the wall posts so the edge of the post is set back 3/4" (19 mm) in from the edge of the base
STEP 3A
Slide straight glass panel all the way into wall post. Mark position of glass post. Remove panel.
3/4"
(19 mm) 
FINISH WALL
EDGE OF BASE
STEP 2
Level both wall posts in their proper position and mark where screw holes are to be drilled. Drill 3/16" holes and secure with wall anchors and screws provided. Cut a 12" strip of tape (provided) and apply firmly over screw heads.
TAPE
6 PLACES)
MARK POSITION
STEP 3B
Apply a bead of silicone sealant on underside of bottom bracket corner post and place bracket where marked. Drill pilot holes (#8 screw) and secure bracket to base. Reinsert panel into wall post and position glass post over bracket.
APPLY BEAD OF
SILICONE SEALANT
ON UNDERSIDE OF
BOTTOM BRACKET
CORNER POST
8