3 WALL: TOWER AND CURVED GLASS INSTALLATION
STEP 1
Position the wall post so the edge of the post is set back 3/4" (19 mm) in from the finish wall.
FINISH WALL |
3/4" |
(19 mm) |
STEP 2
Level the post in its proper position and mark where screw holes are to be drilled. Drill 3/16" holes and secure with wall anchors and screws provided. Cut a 12" strip of tape (provided) and apply firmly over screw heads.
TAPE
3 PLACES)
STEP 3
Slide the glass panel into the wall post. Make sure that the corner notch is positioned toward the base of the tower.
NOTCH
STEP 4
Place the tower onto base. Ensure the curved glass locates into the glazing channel. Install bolt but do not tighten.
BOLT (5/16")
WASHER
GLAZING
CHANNEL
19