UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
1.NOTE: For this procedure, you will need the assistance of additional personnel and an adequate lifting device (not included).
2.Remove the box surrounding the Bandsaw using appropriate tools, being careful not to injure yourself from sharp fasteners.
3.Search for and remove all bolts securing the Bandsaw to the pallet.
Warning: At this point the Bandsaw could easily tip, causing serious in- jury. Have assistants stabilize the bandsaw.
4.Use the lifting device to lift the Bandsaw off the pallet and set it on a flat location on the floor that is capable of properly supporting its weight.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional information regarding the parts listed in the following pages, refer to the Assembly Diagrams on pages 32 and 33.
WARNING! Always make sure the Toggle Switch (11) for the Bandsaw and the Toggle Switch (37) for the Coolant Pump are both in their “OFF” position and the tool is unplugged from its electrical outlet prior to assembling the tool, adding any accessories, or making adjustments to the tool.
A - Attach The Wheels
Note: For this procedure, you will need the assistance of additional personnel and an adequate lifting device (not included).
1.Use the lifting device to raise the Left Leg (2) of the Bandsaw about six inches off the floor. Once the Left Leg is lifted, insert a Wheel Shaft (35) through the two holes located at the bottom of the Left Leg.
2.Slide one Wheel (34) on each end of the Wheel Shaft. Place one Washer (33) on each end of the Wheel Shaft. Insert one Cotter Pin (36) through the hole in each end of the Wheel Shaft. Then, make sure to bend the Cotter Pins to secure the Wheels in place. (See Figure E.)
3.Repeat Steps #1 & 2 for the Right Leg (3), remaining Wheel Shaft (35), and remain- ing Washer (33) and Cotter Pin (36). (See Figure E.)
SKU 93507 | For technical questions, please call | Page 11 |