OPERATING INSTRUCTIONS
WARNING! Always make sure the Toggle Switch (37) for the Bandsaw and the Toggle Switch (11) for the Coolant Pump are both in their “OFF” position and the tool is unplugged from its electrical outlet prior to making adjustments to the tool.
Selecting Proper Blade Speeds:
When using the Bandsaw always change the blade speed to best suit the materi- al being cut. The Blade Speed Chart illustrates several settings for several types of materials. (See Figure K.)
Material | Blade Speed (FPM) | Belt Groove Used | |
|
| Motor Pulley | Saw Pulley |
Tool, Stainless | 86 | Small | Largest |
Alloy Steels, Bearing |
|
|
|
Bronze |
|
|
|
Medium to High Carbon | 132 | Medium | Large |
Steels, Hard Brass or |
|
|
|
Bronze |
|
|
|
Low to Medium Carbon | 178 | Large | Medium |
Steels, Soft Brass |
|
|
|
Aluminum, | 260 | Largest | Small |
Plastic |
|
|
|
FIGURE K
SPINDLE PULLEY | MOTOR PULLEY |
Using The Quick Vise:
The Bandsaw is equipped with a “quick action” vise which allows you to instantly position the moveable Front Vise (94). To operate, turn the Handle Wheel (47) counterclockwise 1/2 turn and move the Front Vise to the desired position. Then tighten the Front Vise against the workpiece by turning the Handle Wheel clock- wise. (See Figure L.)
FRONT VISE (94)
HANDLE WHEEL |
| FIGURE L |
| ||
(47) |
| |
|
|
|
|
| REV 10/06 |
SKU 93507 | For technical questions, please call | Page 15 |