D - Attach The Tool Stop Rod And Block
1.Slide the Stock Stop Rod (74) into the mounting hole in the Table (39), and secure the Stock Stop Rod by tightening the Set Screw (71). (See Figure G.)
2.Slide the Stop Block (73) onto the Stock Stop Rod (74), and secure by tightening the Thumb Screw (72). (See Figure G.)
(WORKPIECE NOT INCLUDED)
|
|
|
|
|
| SET SCREW |
|
|
|
|
|
| |
|
|
|
| (71) | ||
|
|
|
|
| STOP BLOCK | |
|
|
|
|
| ||
THUMB SCREW (72) | (73) | |||||
|
|
| ||||
STOCK STOP ROD (74) |
|
|
|
|
| FIGURE G |
|
|
|
|
|
|
E - Install The Coolant Tank
1.Slide the Coolant Tank (107) out from under the Table (39) of the Bandsaw.
(See Figure H.)
2.Remove the white lid at the top of the Coolant Tank (107), and fill the Coolant Tank to about 80% capacity with a
3.Slide the Coolant Tank (107) back under the Table (39) of the Bandsaw. Then insert the Hose (102) through the hole in the white lid. (See Figure H.)
HOSE (102) |
|
WHITE LID |
|
COOLANT TANK |
|
(107) | FIGURE H |
|
SKU 93507 | For technical questions, please call | Page 13 |