Generac Power Systems 004701-0 owner manual Battery Installation, Optional Accessories

Page 34

Section 2 – Installation

Recreational Vehicle Generator

‹2.6.6 POWER SUPPLY CORD

The power supply cord must comply with all appli- cable codes, standards and regulations. It must be large enough to handle the full amperage to which it will be subjected.

‹2.6.7 GROUND FAULT CIRCUIT INTERRUPTERS

The National Electrical Code (NFPA 70, 551-7) requires that a ground fault circuit interrupters (GFCIs) be installed on all external and some internal electrical receptacles. Contact the dealer for recom- mendations.

‹2.7.3 BATTERY CABLE CONNECTIONS

1.Connect the battery cable from the battery post or terminal indicated by a POSITIVE, POS or (+) to the lug on the starter contactor (Figure 2.16).

NOTE:

Check to be sure the battery cable boot for the starter cable has been installed.

2.Connect the battery cable from the battery post indicated by a NEGATIVE, NEG or (-) to the frame ground connection (Figure 2.16).

3.Connect cables so the connectors are clean and tight.

Figure 2.16 – Connecting Battery Cables

2.7BATTERY INSTALLATION

‹2.7.1 RECOMMENDED BATTERY

Install a battery that meets the following require- ments:

The battery must be a 12-volt, automotive type storage battery.

For prevailing ambient temperatures above 32° F (0° C), use a battery rated 70 amp-hours and capable of delivering 400 cold-cranking amperes.

For prevailing ambient temperatures below 32° F (0° C), use a battery rated 95 amp-hours and capable of delivering 400 cold-cranking amperes.

NOTE:

If the battery is to be used to power other vehicle accessories, as well as start the generator, a bat- tery with a larger capacity may be needed.

‹2.7.2 BATTERY CABLES

Using battery cables that are too long or too small in diameter may cause a drop in voltage, which causes starting problems. For the best cold weather starting, the voltage drop between battery terminals and the generator connection point should not exceed 0.12 volts per 100 amperes of cranking current.

These generators are rated at about 100 DC amperes of cranking current.

Select battery cables based on (a) cable length and

(b)prevailing ambient temperatures. Generally, the longer the cable and the colder the weather, the larger the cable size must be, as shown in the following chart.

 

CABLE LENGTH

 

 

 

in Feet (Meters)

CABLE SIZE

 

 

0 to 10 (0 to 3)

2*

 

 

11 to 15 (3.4 to 4.5)

0

 

 

16 to 20 (4.5 to 6)

000

 

 

 

 

 

* For warm weather, use No. 2 cable up to 20 feet.

71.2 [2 13/16"]

POS. BAT.

34.3CONNECTION [1 3/8"]

NEG. BAT.

CONNECTION

39.6

69.6

[1 9/16"]

[2 3/4"]

‹2.7.4 BATTERY COMPARTMENT

Install the generator battery in its own, vented com- partment. Place the battery compartment away from any source of heat, sparks or flame.

Provide ventilation openings in the battery compart- ment. The minimum size of openings should be 2 square inches at the top of the compartment. Mount the battery on a strong, rigid supporting structure, where leaks and spills of battery fluid will not cause damage.

2.8OPTIONAL ACCESSORIES

A plug-in receptacle (Figure 2.17) is provided on the generator set. Use this receptacle to connect an optional remote-mounted start/stop panel to the generator. Installation of such a panel will permit starting and stopping the generator engine from any convenient location inside the vehicle.

32

Image 34
Contents Air-cooled Recreational Vehicle Generators Authorized Service Dealer Location IntroductionPart II Installation Instructions  Warning   Electrical Hazards  Generator Identification Model Number Serial Number KW Rating Rated VoltageGenerator Applicability SafetySpecifications Generator AC Connection SystemGenerator Control Panel Before Starting the Engine Optional Remote START/STOP PanelStarting the Generator Stopping the Generator ‹ 2.8.1 LOW OIL Pressure SwitchDo not Overload Generator Protection Systems‹ 2.8.3 Field Boost ‹ 2.8.2 High Temperature SwitchAdditional Information ‹ 2.8.4 Overvoltage Protection‹ 2.9.4 Operation in High Grass or Brush Checking the Engine OIL Level‹ 2.9.5 Effects of Moisture and Dirt ‹ 3.3.1 Cleaning the Foam Precleaner Maintaining the Engine AIR CleanerChanging the Engine OIL AND/OR OIL Filter Clean Spark Arrestor Clean AIR IntakeChecking the Engine Spark Plug Battery Maintenance Cleaning the Generator‹ 3.8.2 Every SIX Months ‹ 3.11.2 Return to Service OUT of Service ProcedureAdjusting Valve Clearance ‹ 3.11.1 Removal from ServiceRV Generator Service Interval Tightening Jam NutRecreational Vehicle Generator Part  General Hazards   Fire Hazards  Generator Engine Operating Speed Purpose and Scope ManualEquipment Description Standards BookletsView from TOP Location and Support ‹ 2.1.1 Generator Location‹ 2.2.1 Compartment Size Generator Compartments‹ 2.2.2 Compartment Construction ‹ 2.2.4 Acoustics ‹ 2.2.3 Sound Insulating Materials‹ 2.2.5 Compartment Floor Cutouts Compartment Floor Cutout Drawing 0G3723-A LP GAS Fuel System ‹ 2.3.2 Testing the InstallationCooling and Ventilating AIR ‹ 2.3.1 Generator Airflow‹ 2.4.3 Vapor Withdrawal ‹ 2.4.2 Some Important Considerations‹ 2.4.5 Gaseous Carburetion ‹ 2.4.7 Excess Flow Valve Exhaust System‹ 2.4.6 Fuel Supply Lines ‹ 2.4.8 Leakage TestsElectrical Connections ‹ 2.5.2 Exhaust System Safety‹ 2.5.1 Spark Arrestor ‹ 2.6.1 Electrical Junction BOX ‹ 2.6.3 Generator AC Connections14 Transfer Switch Isolation Method Battery Installation Optional AccessoriesInitial Start Before Initial START-UP‹ 2.8.1 Remote START/STOP Panel Testing Under Load Installation Checklist Troubleshooting Guide Problem Cause CorrectionRecreational Vehicle Generator Electrical Data Supplied by Customer Recreational Vehicle Generator Enclosure Drawing No F4589-B QTY Description Recreational Vehicle Generator Generator Drawing No F4590-C FAN, 8 Curve BLADE, 16.5MM I.D Exploded Views and Parts Lists Regulator Voltage Exploded Views and Parts Lists GUARD, FAN Exploded Views and Parts Lists Long Block Assembly 220 RV LP Recreational Vehicle Generator Regulator Drawing No F5819 CASTING, Twin Regulator Housing MANUFACTURER’S Emission Control System Warranty Coverage Your Warranty Rights and ObligationsPURCHASER’S/OWNER’S Warranty Responsibilities Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule CONSUMER/PERSONAL Applications

004701-0 specifications

Generac Power Systems has established itself as a leading provider of backup power solutions, and one of its standout products is the Generac 004701-0. Renowned for its reliability and advanced features, this model is designed to meet the growing demand for dependable power in residential and commercial applications.

At the heart of the Generac 004701-0 is its robust engine, which offers outstanding performance and efficiency. The unit is powered by a Generac 999cc V-Twin engine, specifically crafted to deliver reliable power during outages. This powerful engine ensures a significant output of up to 22,000 watts, making it suitable for larger homes or businesses that require more energy-intensive appliances to remain operational during outages.

One of the most notable features of the 004701-0 is its innovative True Power Technology. This technology provides clean and stable power, which is essential for sensitive electronics. Unlike some generators that produce a fluctuating output, Generac's True Power Technology ensures that the voltage remains consistent, preventing damage to your appliances.

Another key characteristic of the Generac 004701-0 is its user-friendly controls. The unit comes equipped with a comprehensive LED display that provides vital information at a glance, such as runtime hours and maintenance intervals. This feature ensures users can monitor their unit effectively and keep it in optimal condition.

The generator also boasts an advanced communication system that allows for remote monitoring. With the Generac Mobile Link app, users can check real-time status updates, monitor power usage, and receive alerts directly on their smartphone or tablet. This level of connectivity adds convenience and peace of mind, as users can stay informed about their power systems from anywhere.

Built with durability in mind, the 004701-0 features a corrosion-resistant enclosure that can withstand various environmental conditions. Its weather-resistant design makes it suitable for outdoor installation, ensuring that it remains operational when most needed.

The Generac 004701-0 is also designed with user safety in mind. It incorporates several safety features, including a low-oil shutdown and high-temperature shutdown, which help protect the engine from potential risks. This commitment to safety, combined with its powerful performance and advanced technology, makes the 004701-0 an exceptional choice for anyone looking for a dependable backup power solution.

Whether you're facing a storm, a power grid failure, or simply need reliable power for everyday use, the Generac 004701-0 stands ready to deliver, ensuring that you and your loved ones stay safe and comfortable.