Bush Hog 3860 QT manual PRE-OPERATION Instructions, Transmission Fluid, Initial Loader Operation

Page 14

3. PRE-OPERATION INSTRUCTIONS

IMPORTANT: Do not extend bucket cylinders without quick draw latch attach installed on loader. Failure to follow these instructions could cause attachment cylinder damage and will void loader warranty.

TRANSMISSION FLUID

Check the tractor hydraulic fluid level and fill, if required.

INITIAL LOADER OPERATION

NOTE: Keep engine speed at low idle during the initial loader operation.

CAUTION

ESCAPING HYDRAULIC FLUID UNDER PRESSURE CAN HAVE SUFFICIENT FORCE TO PENETRATE SKIN, CAUSING SERIOUS PERSONAL INJURY. BEFORE DISCONNECT- ING LINES, BE SURE TO RELIEVE ALL PRESSURE.

BEFORE APPLYING PRESSURE TO SYS- TEM, BE SURE ALL CONNECTIONS ARE TIGHT AND THAT LINES, TUBES AND HOSES ARE NOT DAMAGED.

FLUID ESCAPING FROM A VERY SMALL HOLE CAN BE ALMOST INVISIBLE. USE A PIECE OF CARDBOARD OR WOOD, RATHER THAN HANDS, TO SEARCH FOR SUSPECT- ED LEAKS.

IF INJURED BY ESCAPING FLUID, SEE A DOCTOR AT ONCE. SERIOUS INFECTION OR REACTION CAN DEVELOP IF PROPER MEDICAL TREATMENT IS NOT ADMINIS- TERED IMMEDIATELY. REFER TO FIGURE 1.

2

3

1

Figure 1

(1)Hydraulic line.

(2)Cardboard.

(3)Magnifying glass.

EXTERNAL LOADER AND/OR

TRACTOR VALVE

CAUTION

WHEN PROPERLY INSTALLED, THE TRAC- TOR REMOTE VALVE OR EXTERNAL VALVE CONTROL LEVER/LEVERS WILL CONTROL THE LOADER HYDRAULIC CIR- CUITS AS SHOWN IN FIGURES 2 AND 3. REFER TO TRACTOR OPERATOR MANUAL FOR FURTHER EXPLANATION OF TRAC- TOR REMOTE CONTROL LEVER/LEVERS.

IMPORTANT: Contaminants in hydraulic fluid can cause valve spools to stick. BE ALERT when operating loader and follow your tractor Operator Manual hydraulic fluid maintenance schedule.

LOADER MOUNTED CONTROL VALVE EQUIPPED WITH SINGLE LEVER CONTROL HANDLE OR TRACTOR REMOTE VALVE EQUIPPED WITH SINGLE LEVER CONTROL HANDLE

If your loader utilizes a loader mounted control valve equipped with single lever control handle or tractor remote valve equipped with single lever control handle, it will function as described in Figure 2.

Front of Tractor

 

 

 

 

 

 

 

 

 

Figure 2

 

 

 

Number 1 Position:

Pull the joystick back to

 

raise loader.

Number 2 Position:

Push the joystick forward to

 

lower loader.

Number 3 Position:

Push the joystick full forward

 

to activate float position.

Number 4 Position:

Push the joystick outward to

 

dump attachment.

Number 5 Position:

Pull the joystick inward to

 

roll back attachment.

12

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Bush HOG Congratulations Table of Contents 3860 QTThis Limited Warranty Shall not Apply Disclaimer of Implied Warranties & Consequential DamagesDealer Preparation Check List Loader Important Safety PrecautionsTractor Safety Precautions Operating the LoaderEMPLOYERS, Employees and Operations Employee Tractor Operating InstructionsDescription Introduction and DescriptionIntroduction Model 3860 QT Technical Specifications Tractor Preparation Installation InstructionsInstallation Important NoticeSubframe Crosstube Forward SideFront Bracket Lift and Support ALL Loader COMPO- Nents Safely Torque IdentificationInitial Loader Operation PRE-OPERATION InstructionsTransmission Fluid External Loader AND/OR Tractor ValveFloat Position Bucket Level IndicatorNeutral Position Initial Loader OperationRemote Hoses Support Loader Lubrication MaintenanceDaily Checks Bucket Level Gauge ROD General SafetyOperating Instructions OperationFilling the Bucket Lifting the LoadLowering the Bucket Carrying the LoadDumping the Bucket Not this Do this Dump Lower LeverFloat Surface Material Loading from a Bank Operating with Float ControlFloat 3RD CUT , 4TH CUT, ETC Do this Peeling and ScrapingBackfilling Loading LOW Trucks or Spreaders from a PileSoil Pile Back GradingTroubleshooting Procedures Problem Possible Cause Remedy Setting recommendedDismounting the Loader Page Mounting the Loader Page Installation & Operation of Quick Draw Latch Attach Upper channel Weld-in center support Bucket or attachment Installing Bucket or Attachment to Quick Draw Latch Attach Page Removing Bucket or Attachment from Quick Draw Latch Attach Single Tine KIT Bucket AttachmentQuick Draw Bucket Super Penetrator Bale Probe Attachment Operating Instructions for Dismounting Dozer from Loader Dozer AttachmentManure Fork Attachment Pallet Fork Attachment Parking AnglesGrapple Attachment Page Operating Instructions Page Supplemental Instructions For Ford Genesis Special Safety Decals Decals Torque Specifications American
Top Page Image Contents