Bush Hog 3860 QT manual Filling the Bucket, Lifting the Load

Page 19

FILLING THE BUCKET

Approach and enter the pile with a level bucket.

Loaders with 1-lever control, ease lever back and toward you to lift and rollback the bucket.

Loaders with 2-lever controls, ease both levers back to lift and rollback the bucket.

The lift and rollback of the bucket will increase effi-

ciency because...

...a level bucket throughout the lifting cycle resists bucket lift and increases breakaway effort.

NOTE; Do not be concerned if the bucket is not com- pletely filled during each pass. Maximum productivity is determined by the amount of material loaded in a given period of time. Time is lost if two or more attempts are made to fill the bucket on each pass.

LIFTING THE LOAD

WARNING

DO NOT LIFT OR CARRY ANYONE IN THE BUCKET OR ON ANY OTHER PORTION OF THE LOADER OR LOADER ATTACHMENT. INADVERTENT MOVEMENT OF THE LOADER OR ATTACHMENT COULD RESULT IN SERIOUS INJURY OR DEATH FROM FALLING OR CRUSHING.

CAUTION

MAKE SURE MATERIAL IN BUCKET CAN- NOT ROLL OUT AND DOWN ON TRACTOR WHEN BUCKET IS RAISED TO FULL HEIGHT. KEEP CLEAR OF OVERHEAD OBSTRUCTIONS SUCH AS TREES, LIMBS OR POWER LINES WHEN RAISING THE BUCKET

When lifting the load, keep the bucket positioned to avoid spillage.

CAUTION

DO NOT ATTEMPT TO LIFT BUCKET LOADS IN EXCESS OF CAPACITIES LISTED IN TECHNICAL SPECIFICATIONS.

17

Image 19
Contents Bush HOG Congratulations 3860 QT Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyDealer Preparation Check List Tractor Important Safety PrecautionsLoader Operating the Loader Safety PrecautionsEmployee Tractor Operating Instructions EMPLOYERS, Employees and OperationsIntroduction Introduction and DescriptionDescription Model 3860 QT Technical Specifications Important Notice Installation InstructionsInstallation Tractor PreparationFront Bracket Forward SideSubframe Crosstube Torque Identification Lift and Support ALL Loader COMPO- Nents SafelyExternal Loader AND/OR Tractor Valve PRE-OPERATION InstructionsTransmission Fluid Initial Loader OperationInitial Loader Operation Bucket Level IndicatorNeutral Position Float PositionRemote Hoses Support Daily Checks MaintenanceLoader Lubrication Operation General SafetyOperating Instructions Bucket Level Gauge RODLifting the Load Filling the BucketNot this Do this Dump Lower Lever Carrying the LoadDumping the Bucket Lowering the BucketFloat Operating with Float ControlFloat Surface Material Loading from a Bank Loading LOW Trucks or Spreaders from a Pile Peeling and ScrapingBackfilling 3RD CUT , 4TH CUT, ETC Do thisBack Grading Soil PileSetting recommended Troubleshooting Procedures Problem Possible Cause RemedyDismounting the Loader Page Mounting the Loader Page Installation & Operation of Quick Draw Latch Attach Upper channel Weld-in center support Bucket or attachment Installing Bucket or Attachment to Quick Draw Latch Attach Page Removing Bucket or Attachment from Quick Draw Latch Attach Quick Draw Bucket Bucket AttachmentSingle Tine KIT Super Penetrator Bale Probe Attachment Manure Fork Attachment Dozer AttachmentOperating Instructions for Dismounting Dozer from Loader Parking Angles Pallet Fork AttachmentGrapple Attachment Page Operating Instructions Page Supplemental Instructions For Ford Genesis Special Safety Decals Decals American Torque Specifications