Bush Hog 3860 QT manual Decals

Page 44

DECALS CONTINUED

CAUTION

1.USE ONLY FACTORY SUPPLIED CLEVIS AND MOUNTING HARDWARE WHEN ATTACHING TO CLEVIS MOUNTING POINT OF BUCKET.

2.MAXIMUM LOAD LIMIT ON FACTORY CLEVIS AND CLEVIS MOUNTING POINT IS 6500 POUNDS.

3.NEVER TOW ANY POINT OF THE LOADER WITH A CHAIN, ROPE, OR CABLE.

4.DO NOT APPLY TRACTOR PULL OR PUSH FORCE TO THIS CLEVIS MOUNTING

POINT. APPLY ONLY LOADER HYDRAULIC LIFT OR ROLLBACK CAPACITY TO

THIS CLEVIS MOUNTING POINT.

41077

50020844

50021178

CAUTION

TO HELP PREVENT BODILY INJURY,

ALWAYS PARK AND STORE DOZER

ATTACHMENT WITH PARKING STANDS

IN PARKED POSITION.

 

 

36464

 

 

 

50020800

 

 

 

 

 

 

25H49268

 

25H49267

 

 

 

42

Image 44
Contents Bush HOG Congratulations Table of Contents 3860 QTThis Limited Warranty Shall not Apply Disclaimer of Implied Warranties & Consequential DamagesDealer Preparation Check List Loader Important Safety PrecautionsTractor Safety Precautions Operating the LoaderEMPLOYERS, Employees and Operations Employee Tractor Operating InstructionsDescription Introduction and DescriptionIntroduction Model 3860 QT Technical Specifications Installation Instructions InstallationTractor Preparation Important NoticeSubframe Crosstube Forward SideFront Bracket Lift and Support ALL Loader COMPO- Nents Safely Torque IdentificationPRE-OPERATION Instructions Transmission FluidInitial Loader Operation External Loader AND/OR Tractor ValveBucket Level Indicator Neutral PositionFloat Position Initial Loader OperationRemote Hoses Support Loader Lubrication MaintenanceDaily Checks General Safety Operating InstructionsBucket Level Gauge ROD OperationFilling the Bucket Lifting the LoadCarrying the Load Dumping the BucketLowering the Bucket Not this Do this Dump Lower LeverFloat Surface Material Loading from a Bank Operating with Float ControlFloat Peeling and Scraping Backfilling3RD CUT , 4TH CUT, ETC Do this Loading LOW Trucks or Spreaders from a PileSoil Pile Back GradingTroubleshooting Procedures Problem Possible Cause Remedy Setting recommendedDismounting the Loader Page Mounting the Loader Page Installation & Operation of Quick Draw Latch Attach Upper channel Weld-in center support Bucket or attachment Installing Bucket or Attachment to Quick Draw Latch Attach Page Removing Bucket or Attachment from Quick Draw Latch Attach Single Tine KIT Bucket AttachmentQuick Draw Bucket Super Penetrator Bale Probe Attachment Operating Instructions for Dismounting Dozer from Loader Dozer AttachmentManure Fork Attachment Pallet Fork Attachment Parking AnglesGrapple Attachment Page Operating Instructions Page Supplemental Instructions For Ford Genesis Special Safety Decals Decals Torque Specifications American