15. PALLET FORK ATTACHMENT
CAUTION 
FORK TINES MUST BE ADJUSTED OUT- WARD AND LOCKED BEHIND PARKING ANGLES BEFORE PARKING LOADER.
NEVER OPERATE PALLET FORKS WITH- OUT GUARD ASSEMBLY INSTALLED.
WARNING 
TO AVOID SERIOUS INJURY OR DEATH:
★NEVER LIFT LARGE ROUND HAY
BALES OR OTHER LOADS ON THE FORK LIFT ATTACHMENT THAT COULD ROLL BACK ONTO TRACTOR OPERATOR AREA.
★NEVER USE FORK LIFT ATTACHMENT TO LIFT OR SUPPORT PEOPLE.
★TRANSPORT LOADS LOW AND SLOW.
★AVOID CONTACT WITH POWER LINES.
IMPORTANT: When parking loader with pallet fork attached, fork tines must be adjusted out- ward and locked behind parking angles before parking loader. Refer to Figure 1.
INSTALLATION INSTRUCTIONS
IMPORTANT: Refer to pages 29 & 30 for instruc- tions concerning Installing Attachment to Quick Draw Latch Attach.
IMPORTANT: Refer to page 31 for instructions concerning Removing Attachment from Quick Draw Latch Attach.
OPERATING INSTRUCTIONS
The pallet fork attachment has two tines, 44" long, and adjustable from 12" to 50" in width. The opera- tor must keep the load centered and as far back on the forks as possible. Operator must always keep load level. Carry the load low and at a slow speed.
Figure 1
PARKING ANGLES
35