Bush Hog 3860 QT manual Grapple Attachment

Page 38

16. GRAPPLE ATTACHMENT

INSTALLATION INSTRUCTIONS

IMPORTANT: Refer to pages 29 & 30 for instruc- tions concerning Installing Attachment to Quick Draw Latch Attach.

IMPORTANT: Refer to page 31 for instructions concerning Removing Attachment from Quick Draw Latch Attach.

A four tine, two cylinder grapple is available to fit 3860 QT bucket widths of 72, 84, 96 and 102 inches.

The bucket grapple is useful for picking up loose hay or roughage out of stacks, stacking and transporting hay bales, carrying silage, and cleaning up brush. Refer to Figure 1.

Figure 1

NOTE: Optional extended length grapple tines are available on some grapple/bucket configura- tions. Contact Factory for further information.

Install right and left hand grapple pedestal to bucket back using 5/8" x 5-1/2" carriage bolts, flatwashers, and nuts. Install pedestal support using 1/2" x 5-1/2" bolts, flatwashers, and nuts. DO NOT TIGHTEN. Refer to Figure 2.

Figure 2

If your bucket has not been pre-drilled at the factory, then you must mark center line of pedestal support slots and center punch. Remove pedestal assembly and drill 9/16" holes 4 places. Reinstall pedestals. Refer to Figure 3.

Figure 3

36

Image 38

Contents Bush HOG Congratulations Table of Contents 3860 QTThis Limited Warranty Shall not Apply Disclaimer of Implied Warranties & Consequential DamagesDealer Preparation Check List Loader Important Safety PrecautionsTractor Safety Precautions Operating the LoaderEMPLOYERS, Employees and Operations Employee Tractor Operating InstructionsDescription Introduction and DescriptionIntroduction Model 3860 QT Technical Specifications Tractor Preparation Installation InstructionsInstallation Important NoticeSubframe Crosstube Forward SideFront Bracket Lift and Support ALL Loader COMPO- Nents Safely Torque IdentificationInitial Loader Operation PRE-OPERATION InstructionsTransmission Fluid External Loader AND/OR Tractor ValveFloat Position Bucket Level IndicatorNeutral Position Initial Loader OperationRemote Hoses Support Loader Lubrication MaintenanceDaily Checks Bucket Level Gauge ROD General SafetyOperating Instructions OperationFilling the Bucket Lifting the LoadLowering the Bucket Carrying the LoadDumping the Bucket Not this Do this Dump Lower LeverFloat Surface Material Loading from a Bank Operating with Float ControlFloat 3RD CUT , 4TH CUT, ETC Do this Peeling and ScrapingBackfilling Loading LOW Trucks or Spreaders from a PileSoil Pile Back GradingTroubleshooting Procedures Problem Possible Cause Remedy Setting recommendedDismounting the Loader Page Mounting the Loader Page Installation & Operation of Quick Draw Latch Attach Upper channel Weld-in center support Bucket or attachment Installing Bucket or Attachment to Quick Draw Latch Attach Page Removing Bucket or Attachment from Quick Draw Latch Attach Single Tine KIT Bucket AttachmentQuick Draw Bucket Super Penetrator Bale Probe Attachment Operating Instructions for Dismounting Dozer from Loader Dozer AttachmentManure Fork Attachment Pallet Fork Attachment Parking AnglesGrapple Attachment Page Operating Instructions Page Supplemental Instructions For Ford Genesis Special Safety Decals Decals Torque Specifications American