Bush Hog 3860 QT manual Soil Pile, Back Grading

Page 23

Leave dirt in the bucket because dumping on each pass wastes time.

DITCH

SOIL PILE

Operate at right angles to the ditch. Take as big a bite as the tractor can handle without lugging down.

DITCH

Leave dirt which drifts over the side of the bucket for final clean-up.

HANDLING LARGE HEAVY OBJECTS

WARNING

DO NOT USE FRONT END LOADERS FOR HANDLING LARGE HEAVY OBJECTS SUCH AS LOGS OR OIL DRUMS. HANDLE LARGE ROUND HAY BALES ONLY WHEN LOADER IS EQUIPPED WITH BUSH HOG BALE SPEAR ATTACHMENT OR BUCKET WITH 4 TINE GRAPPLE.

HANDLING LARGE HEAVY OBJECTS CAN BE EXTREMELY DANGEROUS DUE TO:

Possibility of rolling the tractor over.

Possibility of upending the tractor.

Possibility of the object rolling or sliding down the loader arms onto the operator.

BACK GRADING

When back grading, the angle between the bottom of the bucket and the ground must not be more than 15 degrees. Refer to Figure 1.

Failure to follow these instructions could cause loader attachment cylinders to fail and void warranty.

15 Degrees

Figure 1

Pile dirt on the high side for easier backfilling on a slope.

21

Image 23
Contents Bush HOG Congratulations 3860 QT Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not ApplyDealer Preparation Check List Loader Important Safety PrecautionsTractor Operating the Loader Safety PrecautionsEmployee Tractor Operating Instructions EMPLOYERS, Employees and OperationsDescription Introduction and DescriptionIntroduction Model 3860 QT Technical Specifications Important Notice Installation InstructionsInstallation Tractor PreparationSubframe Crosstube Forward SideFront Bracket Torque Identification Lift and Support ALL Loader COMPO- Nents SafelyExternal Loader AND/OR Tractor Valve PRE-OPERATION InstructionsTransmission Fluid Initial Loader OperationInitial Loader Operation Bucket Level IndicatorNeutral Position Float PositionRemote Hoses Support Loader Lubrication MaintenanceDaily Checks Operation General SafetyOperating Instructions Bucket Level Gauge RODLifting the Load Filling the BucketNot this Do this Dump Lower Lever Carrying the LoadDumping the Bucket Lowering the BucketFloat Surface Material Loading from a Bank Operating with Float ControlFloat Loading LOW Trucks or Spreaders from a Pile Peeling and ScrapingBackfilling 3RD CUT , 4TH CUT, ETC Do thisBack Grading Soil PileSetting recommended Troubleshooting Procedures Problem Possible Cause RemedyDismounting the Loader Page Mounting the Loader Page Installation & Operation of Quick Draw Latch Attach Upper channel Weld-in center support Bucket or attachment Installing Bucket or Attachment to Quick Draw Latch Attach Page Removing Bucket or Attachment from Quick Draw Latch Attach Single Tine KIT Bucket AttachmentQuick Draw Bucket Super Penetrator Bale Probe Attachment Operating Instructions for Dismounting Dozer from Loader Dozer AttachmentManure Fork Attachment Parking Angles Pallet Fork AttachmentGrapple Attachment Page Operating Instructions Page Supplemental Instructions For Ford Genesis Special Safety Decals Decals American Torque Specifications