Ferris Industries 5901180, 5901181 PTO Power Take Off Switch, Throttle Control, Voltage Indicator

Page 18

Features & Controls

PTO (Power Take Off) Switch

The PTO switch engages and disengages the mower. Pull UP on the switch to engage the mower, and push DOWN to disengage the mower.

Throttle Control

Moving the throttle control fully forward is FULL throttle position. Always operate the unit at FULL throttle when mowing.

Glow Plug Indicator (diesel model only)

Lamp that indicates that the glow plugs are heating. Hold the ignition key in the “HEAT” position until indicator lamp turns off, then turn the key to start.

Voltage Indicator

Lamp that indicates a low voltage condition.

Controls

Choke (gas model only)

Close the choke for cold starting. Open the choke once the engine starts. A warm engine may not require choking. Pull the knob UP to close the choke. Push to knob DOWN to open the choke.

Parking Brake

DISENGAGE

Releases the parking brake.

ENGAGE

Locks the parking brake.

Pull the parking brake lever back to engage the parking brake. Move the lever fully forward to disengage the parking brake. NOTE: To start the unit the parking brake must be engaged.

Deck Lift Pedal, Cutting

Height Adjustment Pin & Deck Lift Lock

Lever

These control the cutting height of the mower deck. Depress the pedal until it locks into the 6” (15,2 cm) position. Place the adjustment pin in the desired cutting height and release the lift lock lever.

Hour Meter / Maintenance Reminder

Measures the time of the PTO being engaged. The hour meter measures the number of hours the PTO has been engaged. The hour meter will flash an initial oil change indicator at 5 hours, and a lubrication reminder every 50 hours. These reminders display for approximately two hours and will automatically reset themselves.

Note: The hour meter will register the passage of time only when the PTO is engaged. The hour meter has a self contained power source so the total hours are always visible.

Oil Pressure Indicator

Lamp that indicates a low oil pressure condition.

Water Temperature Gauge

Measures the engine coolant temperature.

Fuel Tank Cap

To remove the cap, turn counterclockwise.

Fuel Level Gauge

Displays the fuel level in the tank.

Power Outlet

Unit is equipped with a +12VDC, 20A power outlet.

16

www.ferrisindustries.com

Image 18
Contents Description Model NumberFerris Industries 5100798 Date Purchased Table of Contents Operating Safety Safety Rules & InformationSlope Operation Roll Bar Use Fuel and Maintenance Operation TrainingPreparation Children Slope OperationTowed Equipment RIDE-ON Units EmissionsService and Maintenance Maintenance and StorageSafe Handling of Gasoline Roll BAR Instructions Operational WarningsInspection and Maintenance of the Roll BAR Seat Belt All Models Identification NumbersCE Identification TAG Markings CE ModelsSafety Decals Safety DecalsSafety Icons Safety Interlock System Safety Interlock SystemOperational Safety Checks Ignition Switch Features & ControlsSeat Adjustment Lever Ground Speed LeversVoltage Indicator PTO Power Take Off SwitchGlow Plug Indicator diesel model only Hour Meter / Maintenance ReminderGeneral Operating Safety OperationChecks Before Starting Diesel Model Only Priming the Fuel SystemTo prime the fuel system On the water separatorGas Model Starting the EngineStopping the Tractor & Engine Diesel ModelDriving the Tractor Pushing the Rider by HandForward Travel Practice Zero Turn Driving PracticeSmooth Travel Reverse Travel PracticePractice Turning Around a Corner Practice Turning In PlaceExecuting an End-Of-Row Zero Turn To lower the roll bar Attaching a TrailerRaise & Lower the Roll BAR To raise the roll barHeight of Grass MowingMowing Recommendations Tall Grass Requires Incremental CuttingMowing Patterns When and How Often to MowMowing Methods Proper Broadcast MowingProper Mulching Temporary Storage 30 Days Or Less Starting After Long Term StorageDiesel Fuel Recommendations Long Term Storage Longer Than 30 DaysStorage Gas Model Operation Rider Maintenance Regular MaintenanceSafety Items Engine MaintenanceFuel Filter To add fuelChecking / Adding Fuel Gas Hydraulic OIL Filter Change Check / ADD Engine OILCheck / Change AIR Filter Check Hydraulic OIL Level Change Interval Every 500 Hours Filter Part NumberChange Engine Coolant Clean RADIATOR, Screen & OIL Cooler Check Engine Coolant LevelPressurized System Lubrication GreaseOil Battery Maintenance Cleaning the Battery and CablesANTI-SCALP Deck Casters Servicing the Mower Blades Removing the BladeTroubleshooting, Adjustment & Service Troubleshooting the RiderTroubleshooting, Adjustment & Service Troubleshooting the MowerTroubleshooting Common Cutting Problems StreakingSeat Adjustment Ground Speed Control Lever AdjustmentSpeed Balancing Adjustment Neutral Position Adjustment Neutral Position and Return Spring AdjustmentNeutral Adjustment Return Spring AdjustmentParking Brake Adjustment Mowing Height AdjustmentDeck Lift ROD Timing Adjustment Deck Height Pin PositionDeck Leveling Adjustment Deck Lift Spring4 Locations Less Pre-Load Suspension AdjustmentTo adjust the spring pre-load More Pre-LoadPTO Clutch Adjustment Blade Brake CheckBelt Removal & Replacement Pump Drive Belt ReplacementPump Drive Belt Removal PTO Drive Belt Replacement Spindle Drive Belt Removal ReplacementPTO Drive Belt Removal PTO Belt Routing Battery Service Checking Battery VoltageJump Starting with Auxiliary Booster Battery Troubleshooting, Adjustment & Service Engine SpecificationsDimensions ChassisFerris Limited Warranty Belts and Blades

5900621, 5900626, 5901179, 5901178, 5901181 specifications

Ferris Industries, renowned for its innovative approach to outdoor power equipment, has introduced a range of products identified by the model numbers 5900626, 5901179, 5901180, 5901178, and 5900621. These models exemplify the company's commitment to quality and efficiency, catering to both residential and commercial lawn care needs.

The Ferris Industries 5900626 is a stand-out model in the lineup, designed for superior performance and durability. It features a robust engine that ensures reliable operation under various conditions. Equipped with a cutting-edge suspension system, it provides enhanced comfort and stability, allowing users to navigate uneven terrain effortlessly. This model is specifically tailored for those seeking efficiency without compromising on power, making it ideal for medium to large lawns.

Next in the lineup is the 5901179, which is favored for its compact design and versatility. This model is equipped with advanced cutting technology that delivers a clean, precise cut, ensuring a manicured appearance. Its small footprint allows for easy maneuverability in tight spaces, a vital feature for residential landscapers. Moreover, the ergonomic controls enhance the user experience, reducing fatigue during extended use.

The 5901180 model showcases Ferris Industries’ dedication to technological advancement. Featuring an innovative hydrostatic drive system, it provides smooth acceleration and deceleration, allowing for greater control over speed and direction. This model is engineered for those who demand high levels of maneuverability and responsiveness, making it an excellent choice for complex landscaping tasks.

For users prioritizing reliability, the 5901178 model stands out with its heavy-duty construction. Designed to withstand rigorous use, this model can handle challenging landscapes while maintaining performance. The inclusion of maintenance-free components reduces downtime, ensuring that users can focus on their landscaping projects without interruption.

Lastly, the 5900621 model serves as an efficient piece of equipment for commercial users. It combines powerful performance with fuel efficiency, ensuring that operators can complete larger jobs without frequent refueling. The advanced cutting deck technology ensures even grass trimming, enhancing overall lawn aesthetics.

In conclusion, Ferris Industries continues to impress with models 5900626, 5901179, 5901180, 5901178, and 5900621. Each model incorporates features tailored for specific needs, from exceptional cutting performance to unparalleled durability, ensuring that users can achieve optimal results in their lawn care endeavors.