Husqvarna Rider 213 C, 216 Awd manual Troubleshooting schedule

Page 27

Troubleshooting schedule

Problem	Cause


Engine does not start	There is no fuel in the fuel tank

	Spark plug defective

	Faulty spark plug connections or interchanged cables

	Dirt in the carburettor or fuel line

	Starter motor does not turn over the engine


Starter motor does not turn over the engine	Battery ﬂat

	Bad contact between the cable and battery

	Lift lever for cutting unit in wrong position

	Main fuse blown.

	Ignition lock faulty

	Brake not activated.

	Faulty starter motor


Engine does not run smoothly	Faulty spark plug.

	Carburettor incorrectly set

	Air ﬁlter clogged

	Fuel tank vent blocked

	Ignition key defective

	Dirt in the carburettor or fuel line

	Choking or incorrectly adjusted throttle cable


Engine seems to have no power	Air ﬁlter clogged

	Spark plug defective

	Dirt in the carburettor or fuel line

	Carburettor incorrectly set

	Choking or incorrectly adjusted throttle cable


Engine overheats	Engine overloaded

	Spark plug defective

	Air intake or cooling ﬂanges blocked

	Fan damaged

	Too little or no oil in engine

	Ignition defective


Battery does not charge	One or more battery cells faulty

	Poor contact on the battery terminal cable connectors


Machine vibrates	Blades are loose

	Engine is loose

	One or more blades unbalanced, caused by damage or poor balancing after
	sharpening


Uneven mowing	Blades blunt

	Long or wet grass

	Cutting unit skew

	Grass blockage under hood

	Different tyre pressures on right and left sides

	Over-speeding

	Engine speed too low

	Drive belt slipping

English – 27

Image 27

Contents English Rider 213 C Rider 216 Rider 216 AWDContents Symbols KEY to SymbolsKEY to Symbols Introduction Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Lifting lever for the cutting unit PresentationPresentation Cutting unitRelease lever Rider 213 C, Rider Cutting height adjustment leverSeat FuelingDriving Before startingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderCutting tips Stop the engineOther objects which can be thrown out by the blades Interval in hours MaintenanceMaintenance schedule Maintenance Daily maintenance At least once Before startingCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Result in reduced braking ability Adjusting the parking brake Rider 213 C, RiderAdjusting the parking brake Rider 216 AWD Adjusting the throttle wireReplacement of fuel ﬁlter Replacing the air ﬁlterChecking the fuel pump’s air ﬁlter Fuses Check the safety systemChecking the tyre pressure Ignition systemAdjusting the parallelism of the cutting unit When the engine is running. Mind your ﬁngersChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unitRemoving the BioClip plug Checking the bladesCombi Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oilRider 216 AWD Lubricating the belt adjusterChecking the transmission oil level General lubricationTroubleshooting schedule Guard ServiceStorage Winter storageTechnical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only Original instructions 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨