Husqvarna Rider 213 C, 216 Awd manual EC-declaration of conformity Applies to Europe only

Page 31

TECHNICAL DATA

EC-declaration of conformity (Applies to Europe only)

Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel.: +46-36-146500, hereby declares that Husqvarna Rider 213 C, Rider 216 and Rider 216 AWD from 2011’s serial numbers and onwards (the year is clearly stated in plain text on the rating plate with subsequent serial number), complies with the requirements of the COUNCIL’S DIRECTIVE:

of May 17, 2006 ”relating to machinery” 2006/42/EC

of December 15, 2004 ”relating to electromagnetic compatibility” 2004/108/EC.

of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.

The following harmonised standards have been applied: EN ISO 12100-2,EN-836.

Notiﬁed body: 0404, SMP Svensk Maskinprovning AB, Fyrisborgsgatan 3, SE-754 50 Uppsala, has issued reports regarding the assessment of conformity according to annex VI of the COUNCIL’S DIRECTIVE of May 8, 2000 ”relating to the noise emissions in the environment” 2000/14/EC.

The certiﬁcates have the numbers: 01/901/143, 01/901/144

Huskvarna, 31 October 2011

Claes Losdahl, Development Manager/Garden Products (Authorized representative for Husqvarna AB and responsible for technical documentation.)

English – 31

Image 31

Contents English Rider 213 C Rider 216 Rider 216 AWDContents Symbols KEY to SymbolsKEY to Symbols Introduction Pre-delivery service Service journalAfter the ﬁrst 8 hours Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Lifting lever for the cutting unit PresentationPresentation Cutting unitRelease lever Rider 213 C, Rider Cutting height adjustment leverSeat FuelingBefore starting DrivingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderStop the engine Cutting tipsOther objects which can be thrown out by the blades Interval in hours MaintenanceMaintenance schedule Maintenance Daily maintenance At least once Before startingChecking and adjusting the steering wires CleaningRemoving of the machine hoods Result in reduced braking ability Adjusting the parking brake Rider 213 C, RiderAdjusting the parking brake Rider 216 AWD Adjusting the throttle wireReplacing the air ﬁlter Replacement of fuel ﬁlterChecking the fuel pump’s air ﬁlter Fuses Check the safety systemChecking the tyre pressure Ignition systemWhen the engine is running. Mind your ﬁngers Adjusting the parallelism of the cutting unitChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unitChecking the blades Removing the BioClip plugCombi Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oilRider 216 AWD Lubricating the belt adjusterChecking the transmission oil level General lubricationTroubleshooting schedule Guard ServiceStorage Winter storageTechnical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only Original instructions 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨