Husqvarna 216 Awd manual Service position for the cutting unit, Placing in the service position

Page 23

Maintenance

Service position for the cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in the service position

1Position the machine on ﬂat ground. Apply and lock the parking brake. Set the cutting height control in the lowest position and lift up the cutting unit.

2 Release the clip on the front hood and lift off the fender.

3Loosen the spring on the drive belt's belt idler by pulling the spring eye.

4 Place the spring eye in the holder.

5 Lift off the drive belt and hang on the load-relieving hook.

6 Loosen on the cutting height stay and place in the holder.

7Grip the front edge of the unit and pull forwards until it stops.

8 Lift the unit until it stops and a clicking sound is heard.

9 The unit locks automatically in the vertical position.

Restoring from service position

1Grip the front edge of the unit and loosen the lock, fold down and slide in the unit.

2Replace the cutting height stay and the belt. Tension the belt with the belt adjuster.

3Fit the front cover.

4Set the cutting height control to one of the positions 1-10

English – 23

Image 23

Contents English Rider 213 C Rider 216 Rider 216 AWDContents Symbols KEY to SymbolsKEY to Symbols Introduction After the ﬁrst 8 hours Service journalPre-delivery service Location of the controls What is WHAT?General use Safety InstructionsSafety instructions Insure your RiderThis is what you do Driving on slopesChildren MaintenanceTransport Lifting lever for the cutting unit PresentationPresentation Cutting unitRelease lever Rider 213 C, Rider Cutting height adjustment leverSeat FuelingStart the engine DrivingBefore starting Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the RiderOther objects which can be thrown out by the blades Cutting tipsStop the engine Interval in hours MaintenanceMaintenance schedule Maintenance Daily maintenance At least once Before startingRemoving of the machine hoods CleaningChecking and adjusting the steering wires Result in reduced braking ability Adjusting the parking brake Rider 213 C, RiderAdjusting the parking brake Rider 216 AWD Adjusting the throttle wireChecking the fuel pump’s air ﬁlter Replacement of fuel ﬁlterReplacing the air ﬁlter Fuses Check the safety systemChecking the tyre pressure Ignition systemChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unitWhen the engine is running. Mind your ﬁngers Placing in the service position Service position for the cutting unitCombi Removing the BioClip plugChecking the blades Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oilRider 216 AWD Lubricating the belt adjusterChecking the transmission oil level General lubricationTroubleshooting schedule Guard ServiceStorage Winter storageTechnical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only Original instructions 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨