Husqvarna Rider 213 C, 216 Awd manual Cutting unit Combi

Page 30

TECHNICAL DATA

Cutting unit	Combi 94	Combi 94	Combi 103

Cutting width, cm/inch	94/37	94/37	103 / 41

Cutting heights, 7 positions, mm/inch	25-75/0.98-2.95	25-75/0.98-2.95	25-75/0.98-2.95

Blade length, mm/inch	358/14.09	358/14.09	388/15.28

IMPORTANT INFORMATION When the service life of this product has been served and it is no longer used it should be returned to the dealer or to an applicable station for recycling.

IMPORTANT INFORMATION We reserve the right to change speciﬁcations and designs without prior notice so as to implement improvements. Note that no legal claims are valid on the basis of information in this manual. Use only genuine parts for repairs. The warranty is not valid if non genuine parts are used.

30 – English

Image 30

Contents Rider 213 C Rider 216 Rider 216 AWD EnglishContents KEY to Symbols SymbolsKEY to Symbols Introduction Service journal Pre-delivery serviceAfter the ﬁrst 8 hours What is WHAT? Location of the controlsInsure your Rider Safety InstructionsSafety instructions General useDriving on slopes This is what you doMaintenance ChildrenTransport Cutting unit PresentationPresentation Lifting lever for the cutting unitFueling Cutting height adjustment leverSeat Release lever Rider 213 C, RiderDriving Before startingStart the engine Driving the Rider Starting the engine with a weak batteryConnecting the jump leads Remove the cables in the reverse orderCutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance Daily maintenance At least once Before starting MaintenanceMaintenance schedule Interval in hoursCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the throttle wire Adjusting the parking brake Rider 213 C, RiderAdjusting the parking brake Rider 216 AWD Result in reduced braking abilityReplacement of fuel ﬁlter Replacing the air ﬁlterChecking the fuel pump’s air ﬁlter Ignition system Check the safety systemChecking the tyre pressure FusesAdjusting the parallelism of the cutting unit When the engine is running. Mind your ﬁngersChecking the cutting unit’s parallelism Service position for the cutting unit Placing in the service positionRemoving the BioClip plug Checking the bladesCombi Replacing the engine oil LubricationChecking the engine’s oil level Changing the oil ﬁlterGeneral lubrication Lubricating the belt adjusterChecking the transmission oil level Rider 216 AWDTroubleshooting schedule Winter storage ServiceStorage GuardTechnical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨ Original instructions

TECHNICAL DATA

Cutting unit

Combi 94