Husqvarna Rider 213 C, 216 Awd manual Removing the BioClip plug, Checking the blades, Combi

Page 24

Maintenance

Removing the BioClip plug

To change a Combi deck from the BioClip function to a cutting deck with rear ejection, remove the BioClip plug, which is located under the unit.

•Put the unit in the service position, see Placing in the service position.

Combi 94

•Loosen the knob and the bolts holding the BioClip plug and remove the plug.

•Replace the unit in normal position. Fit the BioClip plug in the reverse order.

Combi 103

•Remove the three screws holding the BioClip plug, and remove the plug.

•Tip: Fit three full-thread screws M8x15 mm in the screw holes to protect the threads.

•Replace the unit in normal position.

Fit the BioClip plug in the reverse order.

Checking the blades

To achieve the best mowing results it is important that the blades are undamaged and well-sharpened.

Check that the blades’ attachment screws are tight.

IMPORTANT INFORMATION Replacing or sharpening the blades should be conducted by an authorised service workshop.

The blades should be balanced after sharpening.

Damaged blades should be replaced when hitting obstacles that result in a breakdown. Let the service centre assess whether the blade can be sharpened or must be replaced.

24 – English

Image 24

Contents Rider 213 C Rider 216 Rider 216 AWD EnglishContents KEY to Symbols SymbolsKEY to Symbols Introduction Service journal Pre-delivery serviceAfter the ﬁrst 8 hours What is WHAT? Location of the controlsSafety Instructions Safety instructionsInsure your Rider General useDriving on slopes This is what you doMaintenance ChildrenTransport Presentation PresentationCutting unit Lifting lever for the cutting unitCutting height adjustment lever SeatFueling Release lever Rider 213 C, RiderDriving Before startingStart the engine Starting the engine with a weak battery Connecting the jump leadsDriving the Rider Remove the cables in the reverse orderCutting tips Stop the engineOther objects which can be thrown out by the blades Maintenance Maintenance scheduleMaintenance Daily maintenance At least once Before starting Interval in hoursCleaning Checking and adjusting the steering wiresRemoving of the machine hoods Adjusting the parking brake Rider 213 C, Rider Adjusting the parking brake Rider 216 AWDAdjusting the throttle wire Result in reduced braking abilityReplacement of fuel ﬁlter Replacing the air ﬁlterChecking the fuel pump’s air ﬁlter Check the safety system Checking the tyre pressureIgnition system FusesAdjusting the parallelism of the cutting unit When the engine is running. Mind your ﬁngersChecking the cutting unit’s parallelism Service position for the cutting unit Placing in the service positionRemoving the BioClip plug Checking the bladesCombi Lubrication Checking the engine’s oil levelReplacing the engine oil Changing the oil ﬁlterLubricating the belt adjuster Checking the transmission oil levelGeneral lubrication Rider 216 AWDTroubleshooting schedule Service StorageWinter storage GuardTechnical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨ Original instructions