SAFETY INSTRUCTIONS
•Avoid overfilling. f fuel has been spilt on the
Rider wipe it up and wait until it has evaporated before starting the engine. If fuel is spilt on clothes, change them.
• Be extra careful when handling battery acid. Spilling acid on the skin can cause severe burn injuries. Rinse immediately with water. If acid gets into the eyes this can cause blindness. Contact a doctor.
•Be careful with the maintenance of the battery. Explosive gas is formed in the battery. Never handle the battery when smoking or in the vicinity of naked flames or sparks. Otherwise the
battery can explode and cause severe injuries. | Never smoke in the vicinity of the battery or the fuel. |
• Never drive the machine in an enclosed space. |
|
|
|
| |
The exhaust fumes contain carbon monoxide, |
|
|
|
| |
an odourless, non coloured, toxic and fatal gas. |
|
|
|
| |
• Make sure that bolts and nuts, especially |
|
|
|
| |
attachment bolts for the blade units are properly |
|
|
|
| |
tightened and that the equipment is in good |
|
|
|
| |
order. |
|
|
|
| |
• Never alter the safety devices. Check regularly |
|
|
|
| |
that they function. The machine must not be |
|
|
|
| |
driven with defective or unmounted safety |
|
|
|
| |
devices. |
|
|
|
| |
• Do not alter the setting of the governor and do |
|
|
|
| |
not race the engine. |
|
|
| IIR | |
0 | 5 | 88 | RRE DD | ||
• Reduce the fire risk. Keep the machine clean |
|
|
|
| |
from grass, leaves and other refuse which |
|
|
|
| |
fastens in it. Allow the machine to cool before | Never drive the machine in an enclosed space. | ||||
placing it in the storage area. | |||||
|
|
|
| ||
•Stop and inspect the equipment if you drive over an object. If necessary repair the machine before starting.
•Never make adjustments with the engine running.
•The machine is tested for safety and approved
only for equipment supplied or recommended by the manufacturer.
R I D E R 9 7 0
• The blades are sharp and can cause cutting injuries. Wrap over the blades or use protective gloves when handling them.
•Check the functioning of the brakes regularly. Adjust and maintain them as necessary.
•The BioClip cutting unit should only be used to give high quality results on lawn surfaces that you are familiar with. If the blades of the cutting unit strike an obstacle this could change their spacing and lead to expensive repairs.
Clean the machine regularly from grass, leaves and other waste.
10 – English