Husqvarna Rider 16 manual Adjusting the parallelism of the cutting unit, Removing the cutting unit

Page 31

MAINTENANCE

Adjusting the parallelism of the cutting unit

1. Remove the front hood and right-hand fender, as described on page 21.

2. Undo the nuts on the lift strut.

3. Unscrew the strut (anticlockwise) to lower the rear edge of the hood.

Screw the strut in (clockwise) to raise the rear edge of the hood.

4. Tighten the nuts after adjustment.

5.On completion of the adjustment the unit’s parallelism should be re-checked.

6.Fit the right-hand fender and the front hood.

Removing the cutting unit

WARNING!

Wear protective glasses when dismantling the cutting unit. The spring which tensions up the belt can go off and cause personal injury.

1.Carry out points 1-9 to put the cutting unit in the service position, see “Service position for the cutting unit” on page 33.

2.Remove the bolt (3) and lift off the cutting unit.

Fitting of the cutting unit takes place in the reverse order to removal. See page 26 for details of how to fit the BioClip 90.

When assembling: Make sure that the unit’s “lug” enters the loop correctly on the underside of the machine.

2

1

3

30 – English

Image 31

Contents 101 91 RiderContents II. Slope operation Safety InstructionsSafe operation practices for ride-on mowers General operationIV. Service Dear customer InstructionSerial number Good serviceEngine Transmission Explanation of Symbols Reversing General useDo as follows Driving on slopesChildren MaintenanceBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Lift lever for cutting unit Cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureFitting the cutting unit Installing BioClipChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitReplacing the belts on a BioClip unit Replacing the cutting unit beltsImportant Imformation Placing in service position Service position for cutting unitMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Problem Procedure Trouble Shooting ScheduleStorage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe Work done Date, mileage, stamp, sign Servicejournal RiderPre-delivery service After first 5 hoursServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03