Husqvarna Rider 16 manual Service position for cutting unit, Placing in service position

Page 34

MAINTENANCE

Service position for cutting unit

The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In the service position the cutting unit is raised and locked in the vertical position.

Placing in service position

1.Position the machine on flat ground. Apply the parking brake (1), see page 12. Adjust the cutting unit to the lowest cutting height and lower the cutting unit.

2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).

P

1

3.Remove the two support wheels from under the front hood.

English – 33

Image 34

Contents Rider 101 91Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Instruction Dear customerSerial number Good serviceEngine Transmission Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100Front hood Dismantling of the machine hoodsEngine hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Trouble Shooting Schedule Problem ProcedureStorage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe After first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03