Husqvarna Rider 16 manual Stopping the engine, Release lever

Page 20

DRIVING

WARNING!

Never drive the machine on ground with a slope of more than 15° . Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the end position.

2.Pull back the throttle control and turn the ignition key to the STOP position.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

Release lever

The release control must be pulled out in order for the Rider to be moved when the engine is shutoff.

MAX 15

STOP START

English – 19

Image 20

Contents Rider 101 91Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Instruction Dear customerEngine Transmission Good serviceSerial number Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval Hours Before start 100Dismantling of the machine hoods Engine hoodFront hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Changing the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe Servicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03