Husqvarna Rider 16 manual Replacing the break-pin BioClip

Page 38

MAINTENANCE

Replacing the break-pin (BioClip)

The blades are fitted with a break-pin to protect the BioClip unit and its drive when colliding with obstacles. A domed, spring friction washer is fitted to each blade bolt. The washer must always be replaced with a new washer if the blade bolt is loosened. Otherwise the break-pin can break causing the blades to collide.

Only use original spare parts. A set containing a blade, break-pin and friction washer can be purchased from your dealer.

1.Put the unit in the service position, see “Placing in the service position”.

2.Remove the blade (2A) by removing the blade bolt with washer and friction washer (2B).

3.Remove the remains of the broken break-pin

(3).

4.Make sure the contact surfaces (4) on the blade and the blade mounting are free from metal. Clean if necessary.

5.Fit one new break-pin (5) in the blade mounting.

6.Fit the blade (6), make sure it is fitted as illustrated.

7.Fit a new friction washer (7) with the concave face turned towards the blade.

8.Fit the blade bolt with washer (8). Tightening torque 45-50 Nm (4,5-5 kpm)

2A

2B

5

3

4

6

4

7

8

English – 37

Image 38

Contents Rider 101 91Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Instruction Dear customerEngine Transmission Good serviceSerial number Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100Front hood Dismantling of the machine hoodsEngine hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Changing the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe After first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03