Husqvarna Rider 16 manual Inspecting the safety system

Page 27

MAINTENANCE

Inspecting the safety system

The Rider is equipped with a safety system that prevents starting or driving under the following conditions:

The engine should only be possible to start when the cutting unit is in its raised position and the hydrostat pedals are in the neutral position.

The driver does not need to be seated in the driver’s seat.

Make daily inspections to ensure that the safety system works by attempting to start the engine when one of the conditions is not met. Change the conditions and try again.

Check that the engine stops if you temporarily move out off the driver’s seat while the cutting unit is lowered or the hydrostat pedals are not in the neutral position.

Startmotor

Ignition system

Works

Does not work

26 – English

Image 27

Contents 101 91 RiderContents II. Slope operation Safety InstructionsSafe operation practices for ride-on mowers General operationIV. Service Dear customer InstructionGood service Serial numberEngine Transmission Explanation of Symbols Reversing General useDo as follows Driving on slopesChildren MaintenanceBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineHours Before start 100 MaintenanceMaintenance schedule Daily Maintenance intervalRight-hand fender Dismantling of the machine hoodsEngine hood Front hoodChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureFitting the cutting unit Installing BioClipChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitReplacing the belts on a BioClip unit Replacing the cutting unit beltsImportant Imformation Placing in service position Service position for cutting unitMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Lubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Problem Procedure Trouble Shooting ScheduleService StorageWinter storage Technical Data EU declaration of conformity Only applies to Europe Work done Date, mileage, stamp, sign Servicejournal RiderPre-delivery service After first 5 hoursServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03