Husqvarna Rider 16 manual IV. Service

Page 4

SAFETY INSTRUCTIONS

5.Never allow children to operate the machine.

6.Use extra care when approaching blind cor- ners, shrubs, trees or other objects that may obscure vision.

IV. Service

1.Use extra care in handling gasoline and other fuels. They are flammable and vapours are explosive.

a)Use only an approved container.

b)Never remove gas cap or add fuel with the engine running. Allow engine to cool before refuelling. Do not smoke.

Danger, keep hands and feet away

c)Never refuel the machine indoors.

d)Never store the machine or fuel container inside where there is an open flame, such as in a water heater.

2.Never run a machine inside a closed area.

3.Keep nuts and bolts, especially blade attach- ment bolts, tight and keep equipment in good condition.

4.Never tamper with safety devices. Check their proper operation regularly.

5.Keep machine free of grass, leaves or other debris build-up. Clean up oil or fuel spillage. Allow machine to cool before storing.

6.Stop and inspect the equipment if you strike an object. Repair, if necessary, before restarting.

7.Never make adjustments or repairs with the engine running.

8.Grass catcher components are subject to wear, damage and deterioration, which could expose moving parts or allow objects to be thrown.

Frequently check components and replace with manufacturer’s recommended parts, when necessary.

9.Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves and use extra caution when servicing them.

10.Check brake operation frequently. Adjust and service as required.

English – 3

Image 4
Contents Rider 101 91Contents Safety Instructions Safe operation practices for ride-on mowersGeneral operation II. Slope operationIV. Service Instruction Dear customerSerial number Good serviceEngine Transmission Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for cutting unitSeat Lever for adjustment of cutting heightFuelling Starting the engine DrivingCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverMaintenance Maintenance scheduleDaily Maintenance interval Hours Before start 100Dismantling of the machine hoods Engine hoodFront hood Right-hand fenderAdjusting the brake Checking and adjustment of the steering wiresPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterProcedures on contact with acid Check the level of the battery acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Lubricating the belt adjusterGeneral lubrication Trouble Shooting Schedule Problem ProcedureStorage ServiceWinter storage Technical Data EU declaration of conformity Only applies to Europe Servicejournal Rider Pre-delivery serviceAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03