Husqvarna Rider 16 manual Important Imformation

Page 33

MAINTENANCE

IMPORTANT IMFORMATION

On a BioClip unit the blades are set at an angle of 90° to each other. If this angle changes, the blades may touch and cause damage to the cutting unit.

5.Fitting: First slide on the lower belt, then the upper belt.

Check that the blades appear as shown in the diagram, at an angle of 90° to each other. If not, adjust the belts. While the blade bearing is loose the belts can be slid onto the next tooth.

Tighten the nuts sufficiently so that the bearings are touching the cutting deck but can still be moved.

Tension the belts by turning the cam mechanism on top of the cutting deck. Tighten the nut.

Tighten all the nuts to secure the blade bearings.

6.The belt tension is correct when a force of 10 N pushes the belt in 7 mm.

Fit the safety cover over the belts and refit the lift strut.

Changing the belt on cutting units with side ejection or rear ejection

On cutting units with side ejection or rear ejection the blades are driven by a V-belt. This belt is replaced as follows:

1.Dismantling the cutting unit, see page 30.

2.Undo the bolt on the lift strut and the two screws on the cover. Lift the cover off the cutting unit.

3.Release the spring that tensions the V-belt and prise off the belt.

Replace the new belt by reversing the sequence.

BioClip 103

32 – English

Image 33

Contents 101 91 RiderContents Safe operation practices for ride-on mowers Safety InstructionsGeneral operation II. Slope operationIV. Service Dear customer InstructionGood service Serial numberEngine Transmission Explanation of Symbols Reversing General useDo as follows Driving on slopesChildren MaintenanceBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Lift lever for cutting unit Cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Release lever Stopping the engineMaintenance schedule MaintenanceDaily Maintenance interval Hours Before start 100Engine hood Dismantling of the machine hoodsFront hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Replacement of the fuel filter Checking and adjustment of the throttle wireReplacing the air filter Do not use compressed air to clean the paper filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Inspecting the safety system Check the engine’s cooling air intake Checking the tyre pressureFitting the cutting unit Installing BioClipChecking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unitReplacing the belts on a BioClip unit Replacing the cutting unit beltsImportant Imformation Placing in service position Service position for cutting unitMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Lubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Problem Procedure Trouble Shooting ScheduleService StorageWinter storage Technical Data EU declaration of conformity Only applies to Europe Pre-delivery service Servicejournal RiderAfter first 5 hours Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03