Husqvarna Rider 16 Checking of the fuel pump’s air filter, Check the level of the battery acid

Page 26

MAINTENANCE

Checking of the fuel pump’s air filter

Check regularly that the fuel pump’s air filter is free from dirt.

The filter can when necessary be cleaned with a brush.

Check the level of the battery acid

Check that the level of the battery acid lies between the markings. Top up the cells with only distilled water.

WARNING!

Procedures on contact with acid

External: Rinse well with plenty of water.

Internal: Drink large quantities of water or milk. Contact a doctor as soon as possible.

Eyes: Rinse well with plenty of water.

Contact a doctor as soon as possible.

Batteries emit explosive gas. Sparks, flames and cigarettes must absolutely not be brought into the vicinity of the battery.

English – 25

Image 26
Contents Rider 101 91Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Instruction Dear customerEngine Transmission Good serviceSerial number Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Location of the controls PresentationPresentation Parking brake Throttle and Choke leverSpeed limiter Cutting unit Lift lever for cutting unitFuelling Lever for adjustment of cutting heightSeat Cold engine DrivingStarting the engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100Front hood Dismantling of the machine hoodsEngine hood Right-hand fenderPoorly adjusted brakes can result in reduced braking power Checking and adjustment of the steering wiresAdjusting the brake Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterChecking of the fuel pump’s air filter Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Changing the oil LubricationCheck the engine’s oil level General lubrication Lubricating the belt adjusterCheck the transmission’s oil level Trouble Shooting Schedule Problem ProcedureWinter storage ServiceStorage Technical Data EU declaration of conformity Only applies to Europe After first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03