Husqvarna Rider 16 manual Driving the machine

Page 18

DRIVING

Driving the machine

1.Release the parking brake by pressing down the brake pedal.

2.	Carefully press down one of the pedals until the	2	1
	correct speed is reached.		1
	correct speed is reached.
	To drive forwards: press down pedal (1).
	To reverse: press down pedal (2).

3.Select the required cutting height (1-9) with the cutting height lever.

To obtain a uniform cutting height it is important that the tyre pressures are equal on both front wheels (60 kPa).

English – 17

Image 18

Contents Rider 101 91Contents General operation Safety InstructionsSafe operation practices for ride-on mowers II. Slope operationIV. Service Instruction Dear customerGood service Serial numberEngine Transmission Explanation of Symbols General use ReversingDriving on slopes Do as followsMaintenance ChildrenBattery can explode and cause severe injuries Presentation PresentationLocation of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for cutting unitLever for adjustment of cutting height SeatFuelling Driving Starting the engineCold engine Warm engine Driving the machine Cutting tips Stopping the engine Release leverDaily Maintenance interval MaintenanceMaintenance schedule Hours Before start 100Front hood Dismantling of the machine hoodsEngine hood Right-hand fenderChecking and adjustment of the steering wires Adjusting the brakePoorly adjusted brakes can result in reduced braking power Checking and adjustment of the throttle wire Replacement of the fuel filterDo not use compressed air to clean the paper filter Replacing the air filterCheck the level of the battery acid Procedures on contact with acidChecking of the fuel pump’s air filter Inspecting the safety system Checking the tyre pressure Check the engine’s cooling air intakeInstalling BioClip Fitting the cutting unitChecking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unitReplacing the cutting unit belts Replacing the belts on a BioClip unitImportant Imformation Service position for cutting unit Placing in service positionMaintenance Restoring from service position Checking the blades Replacing the break-pin BioClip Lubrication Check the engine’s oil levelChanging the oil Lubricating the belt adjuster Check the transmission’s oil levelGeneral lubrication Trouble Shooting Schedule Problem ProcedureService StorageWinter storage Technical Data EU declaration of conformity Only applies to Europe After first 5 hours Servicejournal RiderPre-delivery service Work done Date, mileage, stamp, signServicejournal Servicejournal Servicejournal ´*3-G¶5O¨ English ´*3-G¶5O¨ 2001W03