Husqvarna GTH260TWIN Assemble Front Wheel to Mower, Install Mower and Drive Belt

Page 20

2

LB M

KF

A

E

H

S

D

C

ASSEMBLE FRONT WHEEL TO MOWER

1.Using shoulder bolt, washer and locknut from parts bag, assemble front wheel to mower as shown. Tighten se- curely.

INSTALL MOWER AND DRIVE BELT

Be sure tractor is on level surface and engage parking brake.

1. Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

2.Turn steering wheel to the left as far as it will go and posi- tion mower on right side of tractor with deflector shield to the right.

3.Remove plastic tie securing belt, bring belt forward and check belt for proper routing in all mower pulley grooves.

NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor.

4.Slide mower under tractor until it is centered under trac- tor.

5.FIRST INSTALL ANTI-SWAY BAR.

-From right side of mower, insert ant-sway bar (S) into hole in transmission bracket (T).

-Pivot bar towards you and insert other end of bar into hole in rear mower bracket (D). Move mower as needed to insert bar.

-Secure with washer and small retainer spring as shown.

6.ATTACH MOWER SIDE SUSPENSION ARMS TO CHAS- SIS - Position hole in arm (A) over pin (B) on outside of tractor chassis and secure with washer and large retainer spring.

7.Repeat on opposite side of tractor.

8.ATTACH REAR LIFT LINKS - Lift rear corner of mower and position slot in link assembly (C) over pin on rear mower bracket (D) and secure with washer and large retainer spring.

9.Repeat on opposite side of tractor.

10.Turn steering wheel to position wheels straight forward.

11.ATTACH FRONT LINK - Work from left side of tractor. Insert rod end of link assembly (E) through front hole in tractor front suspension bracket (F) and secure with large retainer spring (G) through hole in link located behind the bracket.

12.Insert other end of front link (E) into hole in front mower bracket (H) and secure with washer and small retainer spring (J).

13.Disengage belt tension rod (K) from locking bracket (L).

14.Install belt onto engine clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

15. Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

16.Raise attachment lift lever to highest position.

17.If necessary, adjust gauge wheels before operating mower as shown in this section of this manual.

20

Image 20
Contents Anleitungshandbuch Manuel d’instructionsManual de las instrucciones Manuale di istruzioniPage Safety Rules TrainingII. Preparation III. OperationIV. Maintenance and Storage Sicherheitsvorschriften SchulungII. Vorbereitung III. BetriebIV. Wartung UND Lagerung Règles de Sécurité Précautions D’UTILISATIONII. Préparation III. UtilisationIV. Entretien ET Entreposage Reglas De Seguridad InstrucciónII. Preparación III. OperaciónIV. Mantenimiento Y Almacenamiento Norme Antinfortunistiche Addestramento ALL’USOII. Preparazione III. FunzionamentoIV. Manutenzione E Periodi DI INATTIVITA’ Veiligheidsregels TrainingII. Voorbereiding III. BedieningIV. Onderhoud EN Opslag As rated by the engine manufacturerVitesse Lente HOT Surfaces Drawbar Loading BRAKE/CLUTCH Pedal Züglich MIT Wasser Explosive Gase AUSSPÜLEN. SofortÄrztliche Hilfe AufsuchenLhumidité vaseline afin déviter la corrosion To Adjust Gauge Wheels Einstellen DER TasträderReglage DES Roulettes DE Jauge Para Ajustar LAS Ruedas CALIBRADO- RASAssemble Front Wheel to Mower Install Mower and Drive BeltFirst Install ANTI-SWAY BAR Anmontieren DES Vorderrads AN DEN Mäher Installieren DES Mähers UND DES ANTRIEB- SriemensInstallieren SIE Zuerst DIE SCHWANKSCHUTZ- Stange Montage DE LA Roue Avant SUR LA TON- Deuse Montage DE LA Tondeuse ET DE LA Courroie DE TransmissionMontez D’ABORD LA Barre Stabilisatrice Fixation DES Connexions DE Levage ArrièrePrimero Instalar LA Barra Antioscilación Ensamblar LA Rueda Frontal AL CORTA- CéspedInstalar EL Cortacésped Y LA Correa DE Mando Collegare L’ARTICOLAZIONE Anteriore Installare Innanzitutto LA Barra ANTI-OSCIL- LazioneMontaggio Della Ruota Anteriore SUL Rasaerba DE Maaiunit EN DE Aandrijfriem Installeren Installeer Eerst DE AntirolbarHET Voorwiel OP DE Maaiunit Monteren Hefkoppelingen Links Achter BevestigenPositioning of controls Anordnung der BedienungseinrichtungenEmplacement des commandes Ubicación de los mandosComandi De plaats van de bedieningsorganenCommande des gaz GashebelAcelerador AcceleratoreBrake Pedal BremspedalPédale de frein Pedal del frenoRelevage et abaissement du carter de coupe Elevación/descenso rápidos del equipo de corteSollevamento/abbassamento del tagliaerba Schnelles Heben und Senken des Mähaggre- gatsIgnition Lock ZündschloßClé de contact et de démarrage Cerradura de encendidoParking brake FeststellbremseFrein de stationnement Freno de estacionamientoBlocage et déblocage de la roue libre AcoplamientoyDesacoplamientodeRuedaLibreFree-wheel Control Lever Inserimento/Disinserimento RouoteCruise Control Lever Palanca de mando cruceroTempomat-Hebel Levier du régulateur de vitesseService Reminder/Hourmeter Service Reminder/StudenzählerRappel Entetien/Compteur Horaire Recordatorio Mantenimiento/Cuenta-HorasFilling up Reposición de combustibleTanken Plein de carburantOil level ÖlstandNiveau d’huile Nivel de aceiteDriving . Betrieb . Conduite . Conducción Guida . Rijden Page Hinweis NotaPurge DE LA Transmission Purge TransmissionEntlüften DES Getriebes Transmissie Ontluchten Purgar LA TransmisiónSpurgo Della Trasmissione Nota HinweisRemarque To Move Forward and BackwardPour avancer et pour reculer Moverse hacia adelante y hacia atrásCoupe Utilizar el mando cruceroPer avanzare e retrocedere Vooruitrijden en AchteruitrijdenConseils pour la tonte Cutting tipsRatschläge zum Rasenmähen Maaitips Consigli per il taglio dell’erbaConsejos para el corte Warnung AdvertenciaPericolo WaarschuwingSwitching off the engine Abschalten des MotorsArrête le moteur Apagar el motorAdvertencia Engine hood MotorhaubeCapot moteur Cubierta del motorMaintenance WartungEntretien MantenimientoTo service engine Wartung des MotorsPour assurer lentretien du moteur Mantenimiento del motorService Record WartungsnachweisSchema Dentretien Informe DE ServicioService Aantekeningen Dati DI ServizioOperator Presence System and Reverse Opera- tion System ROS Fahrer-Anwesenheitssystem und Rückwärts- gangsystem ROSControl Sistema Presencia Operador Control Sistema DE Funcionamiento Atrás ROSControllo DEL Sistema DI Presenza Operatore Controllo DEL Reverse Operation System ROSLames BladesMesserbalken Messen CuchillasLame To Check Brake Überprüfen der BremsePour vérifier le frein Controlar el FrenoTo remove mower Entfernen des MähersAssembly of the cutting unit Pour démonter la faucheusePara quitar el cortacésped Per rimuovere la falciatriceTo Replace Mower Drive Belt Austauschen des Antriebsriemens des MähersPour remplacer la courroie de transmission Sustituir la correa de transmisión cortacéspedInstallazione Della Cinghia DI TRASMISSIO- NE DEL Rasaerba Sostituzione della cinghia di trasmissione del rasaerbaDe aandrijfriem van de maaiunit vervangen Rimozione Della Cinghia DI Trasmissione DEL RasaerbaTo Level Mower Visual SIDE-TO-SIDE AdjustmentPrecision SIDE-TO-SIDE Adjustment Ausnivellieren des Mähers Visuelle Justierung AN Beiden SeitenGenaue justierung an beiden seiten Justierung in LängsrichtungPour mettre la tondeuse à niveau Réglage Visuel BilatéralRéglage Bilatéral DE Précision Réglage D’AVANT EN ArrièreNivelar el cortacésped Ajuste Visual DE Lado a LadoAjuste DE Precisión DE Lado a Lado Ajuste DE LA Parte Delantera a LA TraseraLivellamento del rasaerba Regolazione Visiva LATO-LATORegolazione DI Precisione LATO-LATO Regolazione DAVANTI-DIETRODe maaiunit nivelleren Beide kanten op het oog uitlijnenPRECISIE-AFSTELLING BAN Beide Kanten BAN DE Maaiunit Afstelling BOOR-EN AchterzijdeTransaxle Cooling TRANSACHSEN-KÜHLUNGRefroidissement DE LA Transmission Enfriamiento DEL TransejeTo Replace Motion Drive Belt Austauschen des MotorantriebsriemensSustituir la correa de transmisor del movimiento Démontage DE LA CourroieMontage DE LA Courroie Quitar LA CorreaSostituzione della cinghia di trasmissione De aandrijfriem vervangenService Reminder / Hour Meter Service Reminder / StundenzählerRappel D’ENTRETIEN /COMPTEUR Horaire Recordatorio Mantenimiento / CUENTA- HorasTroubleshooting 7. Störungssuche Recherche des pannes . Búsqueda de averías Ricerca guasti . Het localiseren van fouten Service Storage . Aufbewahrung . Remisage . ConservaciónEntretien et réparations ServicioRismessaggio . Stallen ServizioPage 532 40 89-17 Rev 08.18.08 SBW