IBM 09-0572-000 Connecting to Unshielded Twisted-pair (UTP) Cable

Connecting to the Network 2-9
Connecting to Unshielded Twisted-pair (UTP) Cable
1Locate the adapter’s RJ-45 port on the backplate, as
shown in Figure 2-6.
Figure 2-6 Attaching the UTP Cable with the RJ-45 Connector
2Align the RJ-45 plug on the end of the unshielded
twisted-pair cable with the notch on the adapter’s port.
3Insert the RJ-45 plug into the adapter port.
4Connect the other end of the cable to a dual access unit
(DAU), a multistation access unit (MAU), or a controlled
access unit (CAU).
Do not daisy-chain token ring adapters or connect them back
to back.
If you have a NetWare server, proceed to Chapter 3. If you
have any other type of network operating system, proceed to
Chapter 4.
416
RJ-45 port
RJ-45
connector