IBM 09-0572-000 manual Exiting the Program, Using the Command Line

Exiting the Program A-5

To print the help file, first exit the program. At the DOS prompt, enter the print command applicable to your PC software. For example, type:

TYPE 3CTOKENG.HLP> PRN [Enter]

Exiting the Program

To exit the program, press [Esc] until the DOS prompt appears.

Using the Command Line

You can use the command line to run diagnostic tests for 3C619C adapters, or perform other functions. At the DOS prompt, type:

3TOKDIAG <command>

The command line keywords are listed in Table A-3. Each command has parameters that you need to specify. For a complete listing of all parameters, refer to the file INSTRUCT.TXT in the \DIAG directory.

Table A-3 Command Line Keywords

Command	Definition
CONFIGURE	Configures the adapter in one of three ways:
	(1) Automatically with the /AUTO parameter
	(2) Using a specified adapter configuration file
	(3) Using a command line configuration parameter
HELP	Lists all of the available commands and their definitions.
LANGUAGE	Invokes the program in full windows mode in a specified language if an
	external resource file is available for that language.
LIST	Displays a list of installed adapters recognized by this program and their
	assigned adapter numbers.
RUN	Executes the diagnostic tests on a selected adapter and writes the
	results to the screen, a file, or a printer.
	You can get help information for specific commands such as
	RUN by typing HELP, then the command. For example, at the
	DOS prompt (such as A:\>) type:

3TOKDIAG HELP RUN