4Make sure that the settings (memory allocations, interrupts, and so on) for the adapter do not conflict with the PC or other adapter boards installed in the PC.
Refer to Appendix B, “Specifications.”
5Install the adapter in another slot and run the diagnostic tests again to make sure the slot is not defective.
The slot may be defective. If the adapter passes the tests in the second slot, contact the reseller or manufacturer of the PC.
6Install the adapter in another functioning PC and run the tests again.
Your PC may be defective. If the adapter passes the tests in the second PC, contact the reseller or manufacturer of the first PC.
7Check the ring speed (4 or 16).
Use the View
8If you have installed the adapter correctly and you still experience problems, check the software.
Make sure that you have properly configured your PC for the adapter. Refer to Chapter 3, “Using the AutoLink Feature for NetWare,” and Chapter 4, “Standard Installation and Configuration.”
Make sure that you have installed the correct drivers for the network operating system you are running (refer to Chapter 5 or Chapter 6).
9Check for other conflicting devices, such as memory managers or hardware.
10Disable the cache on your CPU.
11Make sure that the bus speed on your PC is between 7.66 and 10 MHz.
