IBM 09-0572-000 manual C Error Messages

C ERROR MESSAGES

This appendix contains an alphabetical list of the error messages that may appear when you use the TokenDisk diskette Configuration and Diagnostic Program for the 3C619C adapter. For information about running the adapter’s diagnostic program, refer to Chapter 7, “Troubleshooting,” and to Appendix A, “Using the Configuration and Diagnostic Program.”

Messages

A diagnostic test name was found in the configuration file at line xxxx. Only configuration parameter variables are allowed. See the INSTRUCT.TXT file in the \DIAG subdirectory of this diskette for a description of the file format.

A lobe cable must be connected from the selected adapter to a retiming concentrator or MAU. The Open Adapter for Ring Operation Test and Adapter Wrap Test both take more than 30 seconds to complete their tasks.

A syntax error was found in the configuration file at line xxxx. The configuration file format is described in the INSTRUCT.TXT file in the \DIAG subdirectory of this diskette.

Adapter failed while trying to read the adapter configuration stored on the adapter. Save a new configuration to the adapter. If the problem persists, swap with a known good 3C619C and try again.

An adapter was configured for EISA mode, but the EISA configuration utility has not run yet. Exit this program, place your EISA configuration diskette in drive A, and reboot the PC.