IBM 09-0572-000 manual Configuration Requirements, Auto Configuring the 3C619C Adapter in an ISA PC

Models: 09-0572-000

1 101
Download 101 pages 45.17 Kb
Page 33
Image 33
Configuration Requirements

4-2 CHAPTER 4: STANDARD INSTALLATION AND CONFIGURATION

The ISA adapter can be configured automatically or manually. Automatic configuration selects configuration values for the adapter. Manual configuration allows you to select the resources yourself.

If you are installing a single adapter and preparing your PC for use as a Novell NetWare DOS client, use the instructions in Chapter 3. If you are running Windows NT or Windows 95, see Chapter 6.

Configuration Requirements

Verify that you meet the following requirements in addition to those stated in Chapter 2.

The 3C619C adapter must be installed in your PC and connected to the network.

No drivers should be loaded.

Auto Configuring the 3C619C Adapter in an ISA PC

To configure the 3C619C adapter in an ISA PC, proceed as follows:

1Make sure the 3C619C adapter has been properly installed in your PC and connected to the network (refer to Chapter 2 for instructions).

2Boot your PC under DOS, version 3.2 or later.

When you configure adapters, memory conflicts may occur. To help prevent this, follow these rules:

a Do not load network drivers.

b Be aware that terminate and stay resident programs (TSRs) may cause memory conflicts.

c If you are using a memory management utility, you must inform it of the address ranges used by the 3C619C adapter. For example, add an exclude parameter to the EMM386 device statement in the CONFIG.SYS file such as:

DEVICE=C:\EMM386.EXE NOEMS X=D800-DBFF

Page 33
Image 33
IBM 09-0572-000 manual Configuration Requirements, Auto Configuring the 3C619C Adapter in an ISA PC