Configuring Mulitple Static IP Addresses

Step 1: Enable Public Network Mode

To enable Public Network mode:

1.Access the Management and Diagnostic Console (MDC) by entering http://gateway.2wire.net/management in your browser’s address bar.

2.In the left-hand navigation menu, click the Local Network - Configure link. The Local Network - Configuration page opens.

3.In the Public Network pane, click the Create a route from the Internet to the public network specified below checkbox. Althernatively, you can use the Home Network - Advanced Settings page to set this information.

Your gateway uses two sets of IP addresses, one for use between the router and the network (usually just 2 addresses) and a second independent set solely for use with end devices. You should have been provided with the second set of IP addresses. For example, you might have been provided with a WAN gateway address of 66.124.231.65 and a WAN IP address for your router of 66.124.231.66, and told that your LAN devices were to use addresses in the range 207.214.87.137 through 207.214.87.141.

4.In the Router Address and Subnet Mask fields, enter the router address and subnet mask provided to you by your ISP.

5.Click the Submit button to save your results.

68

Page 70
Image 70
2Wire 3800HGV-B manual Enable Public Network Mode