3Com 10014302 manual View, Parameter, Description, undo ntp-service unicast-peer

3Com Router Command Reference Guide Addendum for V1.2

undo ntp-service unicast-peer X.X.X.X

View

System view

Parameter

X.X.X.X: IP address of the remote server.

version: Defines NTP version number.

number: NTP version number in the range of 1 to 3.

authentication-keyid: Defines an authentication key.

keyid: The key ID carried in the messages transmitted to the remote server, which is in the range of 1 to 4294967295.

source-interface: Specifies interface name.

interface-name: Interface name. The IP address of the interface will be used as the source IP address of the NTP messages that the local device sends to its peer.

interface-type: Interface type, which identifies an interface along with interface-number.

interface-number: Interface number, which identifies an interface along with interface-type.

priority: Specifies the server to be the preferred server.

Description

Using the ntp-serviceunicast-peercommand, you can enable the NTP unicast peer mode. Using the undo ntp-serviceunicast-peercommand, you can disable the NTP unicast peer mode.

By default, version number is 3, authentication is disabled, and the server is not the preferred choice.

This command sets the remote server at X.X.X.X to be the peer of the local device running in symmetric active mode. X.X.X.X represents a host address, which must not be a broadcast or multicast address, or the IP address of the reference clock. With all these configurations, the local device can synchronize its clock to the remote server and vice versa.

81