Managing CoreBuilder 9000 Switches 27
■Backplane Connections — Displays a table showing the current backplane connections (switch fabric module to interface module) and the status of each connection.
■Trunk Setup — Displays a table showing the trunks, and member ports, currently defined on the device.
IP Configuration Settings
The IP Configuration section contains
■ARP Cache — Allows you to view the Address Resolution Protocol (ARP) cache. The ARP cache is a table of IP addresses learned by the device and their corresponding MAC addresses.
■Interfaces — Allows you to view the IP interfaces defined on the CoreBuilder 9000 Switch. You define interfaces to establish the relationship between the ports on your device and the subnetworks in your IP network. IP interfaces are used for managing the device and to help route packets on your network. You can have up to 32 IP interfaces for management for each device.
■Routes — Allows you to view the IP routes defined on the CoreBuilder 9000 Switch. Each device maintains a table of routes to other IP network, subnetworks, and hosts. You can either make static entries in this table or configure the device using the Routing Information Protocol (RIP).
When configuring the default route, neither a destination address or network mask are required. If the default type is selected the first two fields will be disabled. Only one default route can exist, so if one is already defined, it should not be possible to select the default type.
Chassis Settings
The Chassis section contains the following tabbed pages:
■PSU — Provides detailed information about the power supplies installed in the chassis.
■Fan Status — Allows you to manage and view information about the fan units installed in the chassis.
■Modules — Provides detailed information about the modules installed in the chassis.
