3M 800ab 39600 manual WARNING - Turn off electrical power and disconnect power cord from

Special Set-Up Procedure

WARNING – Turn off electrical power and disconnect power cord from

electrical supply before beginning special set-up procedure. If power cord is not disconnected, severe injury to personnel could result.

Changing Tape Leg Length

(From 70 to 48 mm [2-3/4 to 2 Inches])

The following changes to the case sealer will allow taping boxes 90 mm [3-1/2 inches] minimum height.

CASE SEALER FRAME

1. No changes to case sealer frame are required.

TAPING HEADS

WARNING – Use care when working near tape cut-off knife as knife is

extremely sharp. If care is not taken, severe injury to personnel could result.

1.Lift the lower taping head straight up to remove it from the case sealer bed.

2.Refer to Section II, Adjustments – Changing Tape Leg Length", page 13 for taping head set-up.

Drive Belt Assembly Height

The drive belt assemblies can be raised 48 mm

[2 inches] to provide better conveying of tall boxes.

This change increases the minimum box height that can be taped to 190 mm [7-1/4 inches].

DISASSEMBLE – Figure 5-1

1.Remove and retain the screw (A), cap washer

(B) and spacer (C) from the front and rear arm assembly pivots.

2.Lift belt drive assembly (D) up off the arm assembly pivots.

Note – Keep motor in vertical position to prevent gear oil from leaking out of motor.

Figure 5-1 – Drive Belt Assembly, Disassembly

23