3M™ Digital WallDisplay | Installation and System Setup | |
|
|
|
Hanging the 3M Digital WallDisplay
Unpacking the 3M Digital WallDisplay
1. Place the shipping container face up on the floor and open the end previous opened.
2. Slide the shipping tray out of the shipping container.
3.Remove the accessory box(es) from the top support.
4.Remove the top support.
5.Remove the plastic bag from the 3M Digital WallDisplay by lifting the top of the unit and
pushing the bag towards the bottom of the unit. Then set down the top.
6. Lift up the bottom and remove the bag completely.
7.Remove and set aside the tape holding the projection arm in place.
8. Remove the projection arm shipping foam, by opening the projection arm from the left.
9. Replace the tape to hold the projection arm in place while hanging on the wall.
© 3M 2005. All Rights Reserved. | 17 |
