Introduction | 3M™ Digital WallDisplay |
|
|
WARNING
To reduce the risk associated with hazardous voltage:
•Do not attempt to service the Wall Display other than performing routine lamp replacement. Service should only be performed by a 3M authorized service provider. Aside from the projection lamp assembly, there are no serviceable parts inside the unit.
•Switch power “OFF” and disconnect the plug from electrical outlet before replacing the lamp. Grasp plug and pull to disconnect.
•Replace the power cord if damaged.
•Always plug this product into a grounded outlet.
•Do not use in a wet environment.
To reduce the risk associated with hazardous voltage and fire:
•Switch power “OFF” and disconnect the plug from electrical outlet whenever the unit is not in use for an extended period of time.
•Use a properly rated extension cord. Consult an electrical professional if you have questions.
To reduce the risk associated with muscle strain and impact:
•Use only the 3M™ brand wall mounting hardware kit if wall mounting is desired.
•Strictly follow all installation instructions when installing or removing the Wall Display onto the wall or portable cart.
•Always use more than one person when installing or removing the Wall Display.
•Always keep cart and Wall Display stable.
To reduce the risks associated with glass dust falling from the projection arm into the eye:
• Do not look up towards the projection arm in the event of lamp breakage.
To reduce the risk associated with high temperature related to a hot lamp assembly:
• Wait at least 45 minutes for the lamp assembly to cool before replacing.
To reduce the risk associated with the release of high pressure related to a hot lamp:
• Wait at least 45 minutes for the lamp assembly to cool before replacing.
To reduce the risk associated with unexpected lamp rupture related hazards:
•Ventilate the area where the lamp rupture occurred. The lamp operates at high pressure and at high temperature.
•Have a 3M authorized service provider replace a ruptured lamp.
•Always handle the fragile lamp module with care.
•Wash your hands thoroughly if you come in contact with lamp debris.
•Replace the lamp module when the lamp replacement message appears.
•Never replace the lamp module with a previously used lamp module.
To reduce the risk associated with choking:
• Keep batteries away from children and pets.
To reduce the risk of associated with environmental contamination, due to mercury in the projection lamp:
•Don't throw the lamp cartridge in the trash. Dispose of the lamp cartridge in accordance with your respective governmental agencies for hazardous waste. For disposal information in the U.S., contact the Electronic Industries Alliance at www.lamprecycle.org. In Canada, contact the Electronic Product Stewardship Canada at www.wpsc.ca.
6 | © 3M 2005. All Rights Reserved. |
