A&D SW-60KM, SW-6KS, SW-30KM, SW-60KL, SW-150KM, SW-15KM, SW-15KS, SW-150KL manual

‰Five-level comparator mode…Set the HIHI limit value. Three-level comparator mode…Set the HI limit value.

(No reply for the function setting “aCk 0 “.)

Set the six-digit value excluding the polarity and decimal point.

Command	H	2	,	+	0	0	0	4	0	0	CR	LF
Reply
	H	2	,	+	0	0	0	4	0	0	CR	LF

‰Five-level comparator mode…Set the HI limit value. Three-level comparator mode…Not used.

(No reply for the function setting “aCk 0 “.)

Send the six-digit value excluding the polarity and decimal point.

Command	H	1	,	+	0	0	0	3	0	0	CR	LF
Reply
	H	1	,	+	0	0	0	3	0	0	CR	LF

‰Five-level comparator mode…Set the LO limit value. Three-level comparator mode…Not used.

(No reply for the function setting “aCk 0 “.)

Send the six-digit value excluding the polarity and decimal point.

Command	L	1	,	+	0	0	0	2	0	0	CR	LF
Reply
	L	1	,	+	0	0	0	2	0	0	CR	LF

‰Five-level comparator mode…Set the LOLO limit value. Three-level comparator mode…Set the LO limit value.

(No reply for the function setting “aCk 0 “.)

Send the six-digit value excluding the polarity and decimal point.

Command	L	2	,	+	0	0	0	1	0	0	CR	LF
Reply
	L	2	,	+	0	0	0	1	0	0	CR	LF

Replies to the commands other than examples above when the function setting “aCk 1 “ is selected.

‰The scale is not in a state where a command could be executed. Then, the scale will reply “I”. Command Z CR LF

Reply I CR LF The scale is not in a condition that zero operation is possible.

‰Command does not exist for the scale. Then, the scale will reply “?”. Command B CR LF

Reply ? CR LF The scale received an undefined command.

‰When the function setting “aCk 0 “ is selected, undefined commands are ignored and no reply is sent.

33