11.3. Restoring the factory set values
If the gravity acceleration value or calibration weight value is changed unintentionally, restore those values to the factory setting values, as follows.
Make sure that the scale is in the weighing mode (displaying “kg” (“g”), “lb”, “oz” or “pcs”).
1.Press and hold the TARE switch until the gravity acceleration value appears, and release the switch.
2.Press the UNITS switch twice to display “ClrC” .
.
3.Press the TARE switch to display “ClrC no” with “no” blinking.
4.Press the PRINT switch.
“ClrC no” changes to “ClrC go” with “go” blinking.
5.When “ClrC go” is displayed, press the
TARE switch. The factory setting values
are restored and “end” is displayed.
To finish the restoring procedure, turn the power OFF.
To cancel the restoring procedure, press the
ZERO switch. The display returns to step 2.
Press and hold 
(more than 4 seconds) 
Release 
Press twice 
Press
Press 
Press 
21
