A&D SW-6KS, SW-30KM, SW-60KL, SW-60KM, SW-150KM manual Functions, Setting the parameters, Tare ON/OFF

12. FUNCTIONS

The scale has function settings to specify the scale performance.

The parameters set in the function settings are maintained even if the power is turned OFF.

	Item			Parameter	While
12.1. Setting the parameters					holding down, press
1. Turn the power OFF.
2. Press and hold the				switch and press the
			TARE
	ON/OFF	switch to turn the power ON. The software
	version is	displayed.
‰ “∗∗∗” indicates the software version number.

3. After about one second, the item is displayed.

4. Change the item or parameter using the following switches.

UNITS	To display the next item.
	To increase the value of the blinking
PRINT
	digit by one (to change the parameter).

‰When the parameter is changed, the STABLE indicator turns off.

5.Press the TARE switch to store the setting value.

Press

When changed

After “end”, the power is turned OFF automatically.			Press
‰ To cancel the setting procedure without storing the value, press
the	ZERO	switch. The power is turned OFF automatically.

12.2. To restore the function settings to the factory setting values

1. Turn the power OFF.

2. Press and hold the			TARE	switch and press the			Press
	ON/OFF	switch to turn the power ON. Only release the
	ON/OFF	switch and hold the			TARE	switch until

“Clrf no” with “no” blinking is displayed.

3. Press the

PRINT

switch.

“Clrf no” changes to “Clrf go” with “go” blinking.			Press
4. When “Clrf go” is displayed, press the		switch.
	TARE
The factory setting values are restored. After “end”, the power
is turned OFF automatically.

‰To cancel the restoring procedure, press the The power is turned OFF automatically..

ZERO

switch.

22