Internal Microphone Failure, Microphone Problems

Internal Microphone Failure

If the internal Microphone fails, perform the following actions one at a time to correct the problem. Do not replace a non-defective FRUs:

If internal or external Microphones do no operate correctly, perform the following actions one at a time to correct the problem.

1.Check that the microphone is enabled. Navigate to Start´ Control Panel´ Hardware and Sound´ Sound and select the Recording tab.

2.Right-click on the Recording tab and select Show Disabled Devices (clear by default).

3.The microphone appears on the Recording tab.

4.Right-click on the microphone and select Enable.

5.Select the microphone then click Properties. Select the Levels tab.

6.Increase the volume to the maximum setting and click OK.

7.Test the microphone hardware:

a.Select the microphone and click Configure.

c.Select the microphone type from the list and click Next.

d.Follow the onscreen prompts to complete the test.

8.If the Issue is still not resolved, see “Online Support Information” on page 185.

Chapter 4

101