Actron 9640 user manual ID Meas Spec STS, Ok~, Rich-Ln

Global OBDII Diagnostics

Select Diag Mon Test from OBDII Function List and press ENTER.

OBDII Function List	?
7)O2 Monitor Test	]

`8)Diag Mon Test [ 9)On-Board Systems ~

Applicable tests are displayed . Select	Diag Mon	Data Avail
a test and press ENTER.
	` $01
	$05	[
	$10	~

4 4

Requested test results are displayed on Scan Tool

✓On Non-CAN vehicles Scan Tool displays:

❒On the 1st line is where the test data (test ID) came from.

Non-CAN Vehicles

OR

Diag	Mon Data Avail
` O2	Sensor B1S1
Catalyst B1		[
EVAP (0.090)		~
	CAN Vehicles
TEST $01
ID MEAS SPEC		STS
74 8861 C000min		Low [
76 3876 FFFFmax		OK~

Non-CAN Vehicles

OR

❒ On the 2nd line is the test	O2 Sensor B1S1($00) ?
performed	RICH-LN	Thresh
❒ On the 3rd and 4th line is the
	0.5629(V)	OK [
test measurement (MEAS),
	{O.5629,	0.5629}
specification value (SPEC) and
status (STS). Measurements	CAN Vehicles
and Specification values are

hexadecimal numbers (i.e., $1A, $FE, $11.)

✓On CAN vehicles Scan Tool displays:

❒On the 1st line is where the monitor test data came from. For example ($00)represents the source module id from where the data originated.

❒On the 2nd line is the test performed. The test performed can be $## if test is not defined. Refer to vehicle service manual for details.

❒On the 3rd line are the measured value and units measured in (Volts, Amps, Seconds, etc.) and status of monitor test data.

❒On the 4th line the low and high limits are shown for the monitor test data.

4 – 10 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •