30
8. Remove tumbler (basket) from tumbler (basket) support.
a. Remove the bolt in the center of the tumbler (basket) back wall.
b. Loosen and remove the eight (8) sets of nuts and washers from tumbler (basket) tie rods. Remove the
eight (8) tie rods.
c. Replace either tumbler (basket) or tumbler (basket) support by reversing procedure.

NOTE: Shims might be needed between tumbler (basket) and tumbler (basket) support to insure

proper balancing of tumbler (basket).

9. Reassemble components onto dryer by reversing Step #2 through Step #8.
10. Check tumbler (basket) vertical/lateral alignment and adjust if necessary.
11. Replace back guard.
12. Reestablish electrical power to the dryer.
H. BEARINGS (Refer to illustrations in section F “Pulleys” on page 26)To Replace Rear Tumbler (Basket) Support Pillow Block Bearing
1. Discontinue electrical power to the dryer.
2. Remove back guard.
3. Remove tumbler (basket) pulley.
4. Loosen lateral adjustment jam nuts and bolts. (Refer to illustration in section G “Tumbler (Basket) Alignment”)
5. Loosen two (2) set screws from rear pillow block bearing collar.
6. Remove the rear bearing bolts, securing bearing to bearing mount. Remove bearing.
7. Replace by reversing Step #3 through Step #6.
8. Adjust both lateral and vertical tumbler (basket) alignment.
9. Replace back guard.
10.Reestablish electrical power to the dryer.
To Replace Front Tumbler (Basket) Support Pillow Block Bearing
1. Discontinue electrical power to the dryer.
2. Remove back guard.
3. Follow Step #3 through Step #6 from “To Replace Rear Tumbler (Basket) Support Pillow Block Bearing.”