ADC AD-464 service manual Important do not Overtighten Bolts

17) Reinstall V-belts and tighten the turnbuckle.

IMPORTANT: DO NOT OVERTIGHTEN TURNBUCKLE.

18)Prior to operating the new gear (speed) reducer, fill with 1.4 liters of SAE 90 gear oil.

19)Mount the pillow block bearing on the mounting pads (using the bolts that were removed).

IMPORTANT: DO NOT OVERTIGHTEN BOLTS.

20) Reverse Step #3 from the Pillow Block Removal instructions on page 35.

IMPORTANT: Remove the wooden blocks that were inserted under the tumbler (basket).

NOTE: Verify correct mounting position of the gear (speed) reducer. Make the necessary corrections and/or adjustments to the gear reducer for proper mounting. Changing the drain plug, the breather plug, as well as the turnbuckle mounting pad may be required.

NOTE: Inspect ALL of the work performed, checking for security of parts and proper alignment.

21)Reestablish electrical service to the dryer. g. Retaining Wheel Replacement

1)Discontinue electrical service to the dryer.

2)Remove the front or the rear loading door side panels secured to the front or the rear of the dryer by removing the sixteen (16) 5/16-18 x 3/4" tap bolts, along with the 5/16" flat washers and the 5/16" lock washers.

3)Remove the hardware (i.e., bolt, flat washer, spherical washers, and hex nut) from the wheel mount.

4)Remove the retaining wheel that is to be replaced.

5)Install the new retaining wheel.

Reinstall the flat washer and then the spherical washer on to the 3/8-16 x 3-1/4" bolt, then insert into the hole of the retaining wheel. Add the second spherical washer to the bolt. Holding the retaining wheel in position, slide the bolt through the retaining wheel and out of the hole on the other side of the mount assembly. Add a 3/8" lock washer along with a 3/8-16 hex nut to the bolt hand tight.

37